What is the physical properties (viscosity, thermal conductivity, density and heat capacity) of SAE 10W50 engine oil ?
Would you please inform me a reliable source about it?
Thanks
You can see ASTM standard , it contains more information
Density= 7872 kg/m3
K = 48.8 W/mK
C= 486 J/kgk
Hope this will work. It is high viscosity ester oil...
Hi Santosh
sorry
these info doesn't belong to SAE 10W50
I reached to correct info
Majid,
The following might be helpful for engine oil viscosity:
Covitch, Michael J., et al. "Extending SAE J300 to viscosity grades below SAE 20." SAE International Journal of Fuels and Lubricants 3.2 (2010): 1030-1040.
Hi I'm taking research on "oil cooling" systems in engines especially turbo shaft engines used in Helicopters and I want to know what kind of Heat exchanger used in these systems Can any body...
01 February 2017 8,851 4 View
I want to simulate a train motion in tunnel using dynamic mesh with layering method .as you know layering method used for quadrilateral mesh in 2D simulation.I have multiple cell zones. in this...
02 March 2015 4,853 16 View
Some sources say it is treated as Newtonian as ethylene glycol has a higher viscosity than water, which affects the flow characteristics in simulations. But some also say it is non-Newtonian.
09 August 2024 2,111 2 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...
07 August 2024 5,177 3 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it
06 August 2024 947 1 View
I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?
04 August 2024 1,537 1 View
I want to know more about petroleum deposits in Iran.
02 August 2024 8,725 3 View
I am currently using CASTEP version 2020. When I want to run optical properties calculations with spin-orbit coupling(SOC), I encounter the following error in a pop-up window before the job gets...
02 August 2024 2,890 0 View
What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?
31 July 2024 4,835 3 View
Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...
30 July 2024 906 2 View