Dear All,
Assume there is a inverter and its nominal output power is 500kw. 16 PV strings are connected to it as its input. Each string has 16 module, and each module output 300w at STC.
After rains, grass grows in the summer. 1 of the 16 strings is shaded by grass and other 15 strings are not affected.
Does the inverter change its MPP when the string is shaded, and switch back when the shading disappears in a clear sky day?
In which condtion, the inverter change its MPP?
Is there any event recorded in the inverter management system to check?
My opinion is that it is not true since the inverter is not sensitive to such a string shading. MPP can change when irradiation change apprantly.
Thanks.
Hi,
I agree with you. The inverter does not change its MPP because it is not a smart meter to adapt itself to the new condition (partial shading). I recommend you to read some paper in the field of partial shading of PV strings connected to DC links. They explain this matter in complete details.
Assuming the strings are wired appropriately, there will be very small change in the overall array IV curve and so the inverter MPP won't shift significantly. However, if many strings are shaded then the resulting array IV curve can be distorted substantially and may show more than one maximum power point, of different power outputs. The inverter could lock onto the wrong one and operate the system less efficiently than possible. However, almost all real arrays should be positioned and wired so that this effect can't occur.
I suggest you to read this paper :
https://www.researchgate.net/publication/303318836_Shading_Effect_to_Energy_Withdrawn_from_the_Photovoltaic_Panel_and_Implementation_of_DMPPT_Using_C_Language
Article Shading Effect to Energy Withdrawn from the Photovoltaic Pan...
Answer pretty much depends on the MPPT algorithm onboard inverter.
Traditionnal Hill climbing MPPT might indeed trap on local maximum. In case of 2 (or more) maxima, they would typically stay locked on local maximum with highest voltage, i.e. closest to MPP point without shading.
In your case, only one string is shaded. If shading is uniform over modules of that string, the string will show only one optimum point, likely located at same voltage as the optimum of other strings. In that case total I-V curve of array will also exhibit only one maximum.
Therefore, In your example, Hill climbing MPPT will not be fooled by the shading. You can expect inverter to operate at maximum power of the array. And this result remains true also if shading is not uniform, because 15 other strings are not shaded, they carry the highest power level. Should a second optimum exist, it would be clearly away from the MPP voltage without shade. The loss in voltage (1/16, if shade concentrated on one module) is stronger than the loss in current resulting from the total loss of the string (1/16).
Yet, there exists other stronger shading examples where more than one maximum occurs, and where highest maximum is not at the right side of the IV curve. These cases are rare, as they should be prevented by the geometry of the array compared with potential surrounding shadowers. But these cases exist. For these cases, some inverter makers have developped shadow-proof MPPT, which e.g. intermittently scans the IV curve to detect presence of numerous MMPs.
Quan,
There are several types of MPPT algos, so it becomes to provide you with an answer that applies across the board !
To summarise much of what has been discussed in several of the replies, one of the three possibilitoies exist:
#1 and #3 are the two major issues commonly investigated as cloud transient effects on performance of MPPT's. You can get plenty of literature across the web by doing a simple keyword search.
-Sanjay
- Badges
- Science topic
- Similar topics
- Engineering
- Electrical Engineering