Relevant literature or simple method of knowing which post hoc test to be applied after ANOVA?

Post hoc analysis is done after ANOVA; however, the question of utilising which post hoc test in SPSS remains unanswered. Kindly clarify. Thanks in advance

05 October 2020 3,961 3 View

What is the difference between radiation emitts by white LED lamp and mercury vapor lamp?

Hi friends and senior researchers, While using the white light LED lamp and mercury vapor lamp of same intensity as a radiation source, the radiation impact on the sample shows variation....

10 April 2020 5,280 2 View

What are the current hot research topic in Data Security?

Can anyone suggest currently hot research topic in Data Security.

25 October 2018 6,459 3 View

Can we directly feed producer gas calorific value 1100 kcal/Nm3 in diesel engine at 600 degree celcius??

Normally producer gas is cooled to normal temp and fed to engine fully replacing diesel as fuel. It is done after cleaning and washing then removal of water. As gas is produced at 677 degree...

22 October 2018 6,318 11 View

What is min pressure drop required in order to cool air by expanding in axial turbine. Difference in temp 150 degree. Mass flow 600 kg/hr. ??

Turbo expanders cool air from 450K to 300K. We are planning to use turboexpanders inorder to convert heat into work in interstage of compressors to cool air without much pressure loss. Air flow...

11 October 2018 3,613 2 View

How to Calculate pH of any solution using pH sensor ?

Dear All, I have a pH electrode of BNC probe type ,which will give the output as mV .Can any one help me to convert sensor mV values into respective pH values . Any suggestions /help is highly...

14 March 2018 872 6 View

What is the previous (10years) and current scenarios between Entrepreneurial Orientation (EO), Social Capital (SC) and Technological Dynamism (TD) ?

I need the approach in the entrepreneurial resources which is used to complete the projects including any machine installation or any construction building. This will help me in the filling the...

23 February 2018 2,169 1 View

How to estimate the stator resistance in DTC induction motor?

20 February 2017 9,877 3 View

Does any one have a model of solar cell in PSCAD??

Plz provide a model of PV Cell in PSCAD.

13 April 2016 5,428 1 View

How to do resistance drop compensation for low speed operation of induction motor ?

06 March 2016 6,393 3 View

PScad compatibility with SIMULINK?

Hello, I tried to perform a co-simulation between PScad and SIMULINK. I reviewed the requirements of compatibility between them but I still have no clue about this issue. My PScad is 4.6.3 (x64),...

06 January 2021 8,226 1 View

PI controller Tuning?

Does anyone have any expertise in PI controller Tuning for HVDC model? PSCAD Model is up and running and requires PI controller tuning to achieve the parameters

12 June 2020 803 3 View

How i can Simulate a PV Control System in PSCAD?

I need a book, chapter or something like that which discusses PV inverters. It explains Mathematical relationships and finally Simulates it.

13 April 2020 7,157 6 View

How do I enter multiple points of I-V MOV characteristic from an external file in PSCAD?

I have a multiple points from a I-V MOV characteristic from a equipment datasheet, but PSCAD only allows to enter eleven points. I saw there is an option to enter until 100 points from an external...

28 February 2020 2,737 3 View

MOV modelling using PSCAD?

What are the main parameters that should be entered in pscad for MOV modelling? The MOV will be part of the overvoltage protection circuit of a series capacitor in a transmission line. And how do...

27 February 2020 2,055 2 View

How to prove the stability of the controller mathematically without knowing the transfer function of the system?

The circuit is shown in the attached picture, It is difficult to find the transfer function right know .In the figure Ictrl is the dc current coming after thyristors switching and Irms is the rms...

05 September 2019 10,008 4 View

Can we model or control microgrid using MATLAB Coding ?

02 March 2019 6,836 3 View

PV Grid-Tied Modelling review PSCAD?

Dear Sir, Madame Hello, I am doing my graduation project on 150 KWp PV Grid-Tied network , the grid rating is 400v. I drew the system but I am sure that I have mistakes. I must submit my thesis...

31 December 2018 5,674 0 View

How to fix this error : Make File Error: User library 'Obj_Files_2016_03_25\gf42\MMC_2016_03_25_Exp.obj' does not exist?

How to fix this error : Make File Error: User library 'Obj_Files_2016_03_25\gf42\MMC_2016_03_25_Exp.obj' does not exist in PSCAD? Does anyone help me? Best Regards.

31 December 2018 7,958 2 View

Can anyone provide a PMU model implemented in PSCAD?

I'm currently working on a PMU data analysis study, can anyone provide a PMU model to collect some data through PSCAD simulation ?

31 December 2018 5,715 1 View