I couldn't find the ELSEVIER format journal ""Electrical Power and Energy Systems " for microsoft word,
I can just get a guide for authors
You can convert the following paper to word and use it.
I hope that it would be helpful for you.
All Elsevier journals have the same template.
http://www.journals.elsevier.com/international-journal-of-electrical-power-and-energy-systems/
you can download open access articles and most down loaded
think you
refer to ijepes author information, they have given clearly about the manuscript preparation
See also the following guidelines:
I hope that my suggestions were useful for you.
If you want any thing else, please do not hesitate to tell me.
think you ^_^
Could you recommend some articles on Urban Transportation System optimization and Innovation?
13 August 2024 2,595 3 View
How to develop investments in renewable energy sources?
08 August 2024 5,112 3 View
I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...
07 August 2024 5,177 3 View
I am Looking for a Science Journal with good impact factor and low publication cost to publish a review paper. Your suggestions would be appreciated.
06 August 2024 6,796 3 View
Why is the molecule's orientation with an electric field affect polarizability? Electrons are diffuse enough to be independent with respect to orientation and effect of electric field on...
03 August 2024 7,843 1 View
As authors and academic writers, we usually prepare our manuscript using our own resources. We submit these manuscripts to scientific Journals for peer review and publication sometimes at a fee....
03 August 2024 7,304 2 View
Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...
31 July 2024 5,785 4 View
Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...
30 July 2024 9,824 2 View
After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?
29 July 2024 4,955 0 View
Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...
28 July 2024 6,553 1 View