I am working by using LPG as a fuel.
and combustion begin a diffusion then premixed begin inter by increase the mass of fuel premixed and decrease the mass flow rate of fuel diffusion. and its be the premixed ratio.
the problem i am need paper for any on work in this point thanks a lot everyone
unfortunately the english description of the problem is so unclear, so I really do not understand the question.
Possible stabilisation mechanisms in lifted diffusion jet flames are premixed flame propagation, local quenching due to excessive straining, or autoignition.
i mean. my research is about mixing between diffusion flame and premixed flame.
by control the amount of equivalence ratio and change the amount of premixed mass flow rate and diffusion mass flow rate. all of this with the effect of blockage ratio.
so question is what your opinion about it.
and sorry about bad english writing.
thank a lot
can you post a sketch of your setup?
I assume that you operate a lifted diffusion flame, where the flame burns in a partially premixed mode. You should look for papers on partially premixed lifted flames then, one often finds a socalled triple flame (a rich and a lean premixed flame enclose a diffusion flame), so looking for literature on triple flames might be interesting as well.
- Badges
- Science topic
- Similar topics
- Biological Science
- Histology
- Fixatives