Determine DIANA 3D interface model parameters?

17 September 2020 1 1K Report

Teacher, how to determine the normal stiffness and shear stiffness modulus of the 3D interface model that DIANA simplified microscopic modeling?

And how to determine the parameters of coulomb friction and composite interface in 3d interface model ?

Ab van den Bos Nlyse Consultants

That entirely depends on what material connection you're modelling. We can not give a general answer. You could send your model and we will have a look together.

Badges
Science topic

Similar topics
Engineering
Modeling

More Ning Wang's questions See All

Why does the MFDFA algorithm need to calculate the profile of the time series?

As described in the Multifractal detrended fluctuation analysis (MFDFA) algorithm, it at first calculates the profile of the time series, and then other steps are operated on the profile....

05 August 2024 9,366 2 View

Differences between deep seated landslides and slope destabilization?

Hi, Could someone explain the primary differences between deep-seated landslides and slope destabilization? In particular, definition and characteristics, mechanisms and triggering factors,...

02 August 2024 4,212 2 View

A question about arbuscular mycorrhizal???

How long it takes for arbuscular mycorrhiza to establish and produce benefits under experimental conditions？

25 July 2024 5,208 2 View

Is CFI / TLI = 1 okay in Mplus?

Hi there, I did a CFA to 10 items on 2 latent variables. The model fit is too good and I've never seen it before. CFI / TLI = 1, RMSEA = 0. Is it okay, if everything else was done properly?...

24 July 2024 5,454 7 View

Is it possible to run the AIMD within a system using virtual crystal approximation (VCA)?

I want to study the thermal properties of a mixed system which is constructed by virtual crystal approximation in VASP. When I try to run the ab initio Molecular Dynamics of this system in VASP, I...

19 July 2024 6,569 3 View

If I want to invent my own hypothesis testing method, where should I get started ?

15 July 2024 5,376 5 View

Recommendations for Rapid Publication Journals in Traffic and Transportation?

I am currently working on a research paper focused on the control of Connected and Autonomous Vehicles (CAVs) utilizing multi-agent reinforcement learning methods. At this stage, I am seeking a...

14 July 2024 2,620 2 View

I've earned 1 best paper award and 4 best oral presentation awards. What should I do next?

I've earned 1 best paper award and 4 best oral presentation awards. What should I do next to elevate my academic capabilities to the next level ?

14 July 2024 6,071 5 View

How to start writing an anti-virus software ?

I read several information security books. How do I start writing anti-virus softwares ？

13 July 2024 8,180 1 View

Are my cells contaminated with mycoplasma?

I suspect my cells are contaminated with mycoplasma. I fixed the cells with 4% PFA and stained them with DAPI. Below is the image I obtained. I don't observe the typical small, rounded DAPI foci...

11 July 2024 7,786 3 View

What are the shear and normal stiffness values of an LLDPE liner in 3D numerical modeling of a stockpile?

I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...

05 August 2024 3,665 0 View

Element deletion problem in ABAQUS/Explicit solver using Cohesive elements?

I had a problem for so long. I could easily delete elements in ABAQUS implicit solver but I needed to use VUMAT so I had to have Explicit solution but the element did not disappear for so long. I...

23 July 2024 10,032 0 View

How to solve this error while I simulate gidl using tcad ?

There is an error message "interface silicon/oxide not found in grid xxx.tdr file"

26 June 2024 5,551 0 View

How can I calculate accurate brick-joint interface stiffness for masonry in DIANA FEA?

Greetings everyone. To define the interface between mortar and brick during the modeling of masonry, I need normal and shear stiffness (Kn and Kt). I have tried some relationships found in the...

23 June 2024 6,015 0 View

How to integrate NetSim with Gymnasium for Reinforcement Learning Algorithms?

Hello everyone, I am working on a deep learning power control project using NetSim. So far, I have successfully implemented a tabular Q-learning algorithm and obtained positive results. Now, I am...

21 June 2024 5,576 2 View

What can the authors say about the interface problem between the concrete core and the CFRP shells? What is the adhesion type like?

I submitted my journal and got some comments, I have answered and corrected all the comments from the reviewer but I don't understand how to answer this question. any expert researcher help me to...

20 June 2024 3,802 1 View

For an interface of 2 slabs of 2 materials in DFT calculations, is there any way to local calculate stress tensors in both slabs separately?

Hi, I am using VASP to simulate interface of 2 block material slabs. After bringing them together I can get the stress tensor for the whole simulation box from OUTCAR. However, is there any way to...

23 May 2024 3,500 1 View

Which interface layer can be evaporated at 100-200°C in forming a two-layered structure through multilayer formation?

What type of interface layer is appropriate for evaporation within the temperature range of 100-200°C when creating a two-layered structure using multilayer formation? Specifically, discuss the...

29 April 2024 5,640 2 View

During npt equilibrium space is forming at the bialyer and water interface,why?

I am working on lipid bilayer and used water as a solvent. During npt space is formed at the water and bilayer interface. I had performed 4 steps of npt for 1ns, in the 3rd step there was the...

16 April 2024 5,376 0 View

Consciousness and controlling a neocortical brain-machine interface are energy expensive: some consequences?

In 1980, Fred Miles proposed (contrary to the views of Masao Ito 1972) that the purpose of the cerebellum is to house efference-copy representations of all movements being commanded by the...

11 April 2024 1,695 0 View