Hi Every body
I want to determination Minoxidil and minoxidil oxothiazolidine carboxylate in hair growing.
Introduce a method by HPLC-DAD or UV.
Dear Dr Mahsa
could you please clarify the goal of your research?
Thank you
Sincerely
Chiara
Hi dear Chiara
I am the head of the Cosmetics Control Laboratory. Since the use of minoxidil in cosmetic products has been banned, we need to set up a method to be able to check the safety of these products.
I have a Karl-Fischer reagent (for volumetric titration, which is a one-component reagent) with a titer of 5mg/ml. All references unanimously say the Karl-Fischer solution loses its capability...
02 July 2024 5,044 3 View
Greetings and Regards I have a question about bibliometric articles about public health or nursing. If any of the researchers have experience or knowledge in this matter, please tell me. Thank You
15 June 2024 2,795 1 View
Hi everyone Is there any guideline for method validation for cosmetic? I wanna know about criteria for that.
31 May 2024 1,990 2 View
I am working on a project to detect genetic mutations in lung cancer using machine learning algorithms and I am new to genetics and medical sciences. Can I use RNA as input to the algorithm for...
13 May 2024 5,726 6 View
Generally when they want to use hydrogel for MTT assay, firstly they fix hydrogel with glutaraldehyde then use for MTT assay. so, now, i have self healing hydrogel and its have crosslinker in its...
11 May 2024 6,310 1 View
Hi Have a nice day I want to determination PAAs and PAHs in tatoo. Would you present and introduce methods to this?
02 April 2024 6,772 0 View
"Hi, I gasify the polyethylene terephthalate granules and mold them using a hot press at a temperature of 260 degrees Celsius to prepare a bulk sample. However, after molding with the hot press,...
31 March 2024 8,668 0 View
I have a dataset from lung cancer images with 163 samples (2D images). I use the fine-tuning of deep learning algorithms to classify samples, but the validation loss did not decrease. I augmented...
21 March 2024 8,344 6 View
Hello, I want to dissolve polyphthalamide in a solvent. I tested different solvents, formic acid, toluene, DMSO, alcohol-based solvents, etc. under high temperature and time, but it did not...
12 March 2024 3,030 1 View
Hi. I need to remove all microplastics of a wastewater sample without changing any physicochemical properties of the sample. Can filtration by Whatman filters (for example Whatman 589/3 with...
08 March 2024 8,722 3 View
A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...
11 August 2024 9,801 2 View
Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!
11 August 2024 3,770 4 View
A website software of Blackbody radiation law expert software can used through the following web site. http://39.105.188.151:3000/index
07 August 2024 1,706 0 View
I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....
31 July 2024 3,843 7 View
How can we calculate the percentage of configuration interaction (CI) in the UV output data of the Gaussian program? for example: Excited State 17: Singlet-A 5.1359 eV 241.41 nm...
28 July 2024 9,165 2 View
I was performing estimation of Total Soluble Sugar content in bacterial cultures by Anthrone method. Out of 9 samples, only one sample showed positive reading while others had a negative reading...
22 July 2024 9,576 4 View
i need to find ECC for 4-MIMO antenna using radiation pattern on CST
16 July 2024 7,291 1 View
For example, oxazine type moieties which forms diastereomers, how the separation can be done? Chiral HPLC is the only possibility?
10 July 2024 1,519 3 View
Hi, I need to measure the real-time (or temporal intervals) thickness variation of a transparent material from dry to wet/humid conditions, however, I cannot use the following techniques: -...
08 July 2024 4,799 4 View
I'm attempting to simulate a crossed dipole antenna. For excitation, I've placed a lumped port along each dipole. However, the resulting radiation pattern is similar to that of a single dipole....
08 July 2024 1,876 3 View