Hi TRNSYS users,

I am new into TRNSYS and would like to model a smart system that can extracts energy from the output of a cooling mode heat pump and use it in either of the following ways:

During the cold period, I would like to exchange the heat with an underground loop to heat a district. The water is preheated by a ground heat exchanger. During the hot period, I would like to exchange the heat with a ground heat exchanger as a storage medium.

I also want the system to consider the the heating and cooling seasons so that the system goes through the first mode between October and June and through the second mode between July to September.

Since HP and pump components have one control signal, how can I conglomerate the signals with simple controllers? Should I use microprocessor controller and if so, I would appreciate it if you could give me a hint on how to use it as the documentation is vague.

Regards

Shams

More Shamsoddin Ghiami's questions See All
Similar questions and discussions