Dear Sir, What is the data source tofind out ISO 14000 companies?

More W A S Weerakkody's questions See All

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

What information can be had from raman at higher wavenumber?

i have recorded raman spectra of strontium oxide thin film. the spectra were recorded in the range 400 to 4000 cm-1. i have reference to peaks upto 1000cm-1. but i couldn't find literature for...

26 February 2021 2,499 1 View

What are the methods used for CNT..?

Respected Professor's i hope you are doing well and happy. i need some information about carbon Nanotubes. before blending the CNT with the matrix the CNT has been introducing in some treatments....

24 February 2021 5,383 5 View

Langevin Dynamics in shear flow?

Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...

23 February 2021 1,761 1 View

Monte Carlo simulation?

Hi, i am conducting a Monte Carlo simulation for my new distribution but the MSE values are increasing while the sample size increase, does any experience this issue before and what should i do...

22 February 2021 3,680 4 View

How we can measure Kemp % in wool without using of benzene?

Would you please let me to know about the methods for measurement of medullation and Kemp % on animal? My problem is that the wool sampling and sending to laboratory is not possible. So I would...

21 February 2021 7,260 4 View

Which is the best software or programming language (user friendly) for analysing data?

I have a basic knowledge on Python, R and MATLAB in analysing data. Among those, which is the best and user friendly? Which one should I learn deeply to analyse data?N:B: I want to learn data...

20 February 2021 3,950 15 View

Hi..how to isolate crude HDL (all subfractions) from human serum by size exclusion chromatography?

I would like to know about isolation of crude HDL from serum by SEC. Is it possible to perform with a serum sample volume of

19 February 2021 5,576 2 View

What is the reason film thickness increased?

what is the reason film thickness increased when increased doping concentrations give some reasons The measured film thickness is 156, 282, 394, 548 and 681 nm for 0, 1.5, 2.5, 3.5, and 4.5 wt....

17 February 2021 8,987 5 View

ASTM or ISO standard test for duplex coatings?

Dear all, I would like to conduct scratch and linear reciprocating tribo-test on my magensium alloy, which has a plasma electrolytic oxide (PEO) layer of about 20 um and 10 - 20 um of Parylene...

25 January 2021 9,709 2 View

ISO antibody against BFP for FFPE IHC?

Suggestions and recommendations welcome. Any usage/protocol experience would also be helpful/appreciated. Cheers

22 December 2020 599 3 View

How to get dry petri dishes in glass after wet sterilization?

Hi, I warping my plates with paper, later put them in the autoclave (use wet sterilization cycle) but still some plates are get wet after ends the cycle. How to get dry the petri dishes? and if...

13 December 2020 8,062 4 View

No title

I am a PhD student, and the doctor asked to do a lecture on ISO 9000, 14000, 17000, 118000,22000 18091,27000 and I would like to prepare the lecture. Is it possible to help me with these...

15 November 2020 8,068 3 View

What for is saturrated sodium chloride solution in ISO 12966-2 ?

Hi, everyone. Our lab is going to use ISO 12966-2 and 12966-4 and there is one moment in sample preparation (rapid transmethylation method under alkali-catalysed conditions) that I can't...

15 September 2020 3,229 4 View

The ISO 14040 series standards, Life Cycle Assessment, Is it important?

What do you think about the importance and value-add of The ISO 14040 series standards, Life Cycle Assessment? In general and especially in petrochemical industry.

04 June 2020 3,580 10 View

Relationship between STEP AP209 and CGNS?

Could you please share your knowledge/experience about the relationship between STEP AP209 (ISO 10303: AP209) and CGNS: - Does AP209 covers/supports CGNS 100%? - Where can I read more about the...

22 March 2020 6,625 4 View

Hi, I want to know a standard method for determining the antimicrobial activity of thin films or coatings?

I want to know the standard procedure. For example, ISO 22196 is one of the standard guideline to test the antimicrobial activity of coatings, but it's on purchase document. Does any one know...

01 February 2020 9,425 4 View

How can any lab compare the results of Inter Lab Comparison in context of Quality Assurance (ISO 17025), if the test result is qualitative in nature?

For example, if lab conduct test like full shoe flex based on SATRA TM 92 which results in Qualitative comments (Sole Crack, upper damage etc.)

31 December 2019 6,628 3 View

How to combine Software Asset Management and Blockchain (scientific studies) ?

Hello Scientists, I am currently writing my thesis in German about Software Asset Management (SAM) and trying to integrate the trend topic "Blockchain" as a UseCase. So far I have only found one...

10 November 2019 964 3 View

Fernando Gonzalez Aleu

I found this, but it is not really update

http://www.ehso.com/EHSservices/iso14new.htm

Good luck

Asit Kumar Batabyal

The link (provided by Mr. Fernando) gives information of 2010. It seems to be the last updated report on ISO 14000 companies in the public domain.

Probably, ISO has stopped the publishing of updated reports in the public domain. You may inquire the same from ISO HQ or any ISO certification agency working in your country.

Regards