Could CARS microscopy be performed using a oil immersion objective?

Avinash Mithilesh Singh @Avinash_Singh33

04 April 2017 0 7K Report

Most of the literature reports that I have came across mention high numerical aperture water immersion objectives for CARS microscopy. Is is appropriate to use a oil immersion objective?

Badges
Science topic

More Avinash Mithilesh Singh's questions See All

Is the glass transition temperature the same as the melting point for the glass forming solvents like ethanol?

Are glass transition temperature and melting point the same for glass forming liquids?

08 September 2016 1,303 0 View

Can anyone refer to some paper reporting the photophysics of aminocoumarins studied at low temperatures in non-polar solvents ?

I am not able to locate any reference where aminocoumarins have been studied at low temperatures in non-polar solvents?

08 September 2016 4,126 1 View

Is the LE (locally excited) state always the precursor for the ICT (Intramolecular charge transfer) state?

If this is not the case what kind of temporal profile one can expect in transient absorption spectroscopy for both these states?

07 August 2015 3,755 1 View

Can anyone suggest a good apparatus for setting magic angle in Transient absorption spectroscopy?

Can anyone suggest a good apparatus for setting magic angle in Transient absorption spectroscopy? E.g berek waveplates

06 July 2015 4,627 3 View

How can I prepare virus for a TEM or SEM imaging?

I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?

11 August 2024 3,115 1 View

Is there anyone with experience in TEM analysis who can assist with a manuscript for an upcoming journal?

Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...

07 August 2024 9,563 0 View

How to heat polymer for about 130° without oil bath ?

is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it

06 August 2024 947 1 View

Weak DAPI staining after immunohistochemistry - how to improve?

After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...

05 August 2024 9,637 2 View

Which distribution type should I use when calculating the average particle size from TEM image? and how to calculate the error ?

average particle size calculation from TEM

04 August 2024 2,921 1 View

Is it necessary to covary exogenous constructs in a structural model?

I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...

03 August 2024 6,028 4 View

Do you think can be any gas and oil bearing rocks in Eastern part of Iran?

I want to know more about petroleum deposits in Iran.

02 August 2024 8,725 3 View

In SEM, if a latent variable consists of three observed variables, and each observed variable has four items, what should I do?

Suppose I am studying the construct of "Academic Motivation" (latent variable) in students, which is measured through three observed variables: "Intrinsic Motivation," "Extrinsic Motivation," and...

31 July 2024 3,913 6 View

Please guide me how to prepare samples for zeiss confocal microscope?

i am working on ischemic stroke. for immunoflourescence i want to use zeiss confocal microscope.before i used VS120 but the images from vs120 not so good now i want to use zeiss confocal but i...

30 July 2024 2,349 1 View

I have synthesized a composite of ZnO and In2O3 with variations in ZnO content. In Raman , what is the peak observed at 130 cm-1?

Dear all, I have noticed, as the ZnO content increases, the Raman intensity at 100cm-1 also increases. However, there is a peak nearby at 130 cm-1, which I could not find in any paper related to...

28 July 2024 5,410 1 View