Any one with experience in LS-DYNA who can assist me to solve the following problem: I am modeling vehicle crash using LS-DYNA. The termination time is set to 150 ms. But after 50 ms, the d3plot is not displayed and there is no time history after 50 ms. What could be the reason? and how can I solve the problem so that the simulation continues up to 150 ms?
Thanks in advance for your support.
Bernard Munyazikwiye, University of Agder-Norway.
Hello, I am not expert. But you should check your termination criteria. Do you have other termination command activated?
You should check the time step after 50 ms, since the model deformation can lead to its significant reduction, therefore, despite the fact that the solver is still working, you will not see any results being plotted. Ofcourse, it is only one of possible causes here.
Dear Jakub,
*DATABSE BINARY EXTENT 2ND KEYWORD- IEVERP- set to 0 , (which says more than 1 state to be plotted in each plotfile)
Pls see if this helps
- Badges
- Science topic
- Similar topics
- Engineering
- Modeling