Can you help me explain why I see a cut-off (red circle) in this cyclic voltammogram ?

23 April 2024 1 10K Report

Hello, the image below is my cyclic voltammogram for a redox reaction with a metal and a ligand. Should I change certain parameters from during analysis? Or do you have any recommendations.

Thank you very much.

Sincerely,

Flynne D.

Robert Adolf Brinzer

What is the oxidation state of your metal? Could be the metal is getting poisoned so not all of the bulk material is returning to the original state.

Badges
Science topic

More Ma. Flynne Dagalea's questions See All

How can we improve storage conditions of museum objects?

90% of museum objects worldwide are in storage.

21 July 2024 8,038 6 View

How to removal of dead cells and debris from organoid cultures?

I'm currently working with human pancreatic organoids and I am wondering to remove the dead cells and debris from health organoids, any suggestions would be appreciated!

17 July 2024 8,330 1 View

Does it work as antibiotic resistance if plamid has no RBS??

I am on gene work to express gene of interest in some Bacillus species. Thus far, i need to try some RBS in Vector which is optimized for bacillus subtilis. Before i design vector to express in...

11 July 2024 7,847 1 View

Can a liquid metal-ligand sample be directly analyze in flame atomic absorption spectrosocopy?

Can I directly analyze a liquid metal-ligand sample without acid digestion in flame atomic absorption spectroscopy?

25 June 2024 1,866 2 View

Is this a mixed methods approach?

For my PhD dissertation: If Chapter 1 is a systematic literature review (QUANTS/QUALS) while Chapters 2, 3, and 4 are empirical chapters (QUALS), is this considered a mixed methods research...

16 June 2024 3,220 5 View

What can I do if primer solution gives band in electrophoresis before PCR reaction?

Trouble 1: I ran a PCR reaction and found a low molecular weight band (100 bp) when doing electrophoresis. 1ng plasmid (OD260/280=1.84) was used as template. Final concentration of primers was...

13 June 2024 5,540 6 View

How to find the original questionnaire of the article-Dimensional analysis of schoolchildren’s food label comprehension: a pilot study?

27 May 2024 2,551 0 View

Why the Mixed mode simulation always exit with status 0?

I encountered some issues while simulating the transient characteristics of a device using Mixed Mode. After executing the following codes, an error message "Simulator has unexpectedly exited with...

23 May 2024 2,238 0 View

Can bands of cell lysate be seen during SDS-PAGE?

I want to detect my target protein through WB and it worked well before. But now I could not get any signal for both my target and the GAPDH, so I ran SDS-PAGE. I expected many bands on the gel of...

23 May 2024 613 6 View

Can I ask for a JCPDS card no. 01-083-1436 or CPDS file number 00-031-1979 for urea?

Can I ask for a JCPDS card no. 01-083-1436 or CPDS file number 00-031-1979? I need to index a urea derivative compound to the face-centered tetragonal structure, JCPDS card no....

15 May 2024 9,751 2 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Why don't d-orbitals split themselves, why does it take a ligand? why don't protons from ligand repel nucleus split d-orbitals?

why don't d-orbitals split themselves because of themselves without the presence of ligands? Electrons are indistinguishable. Why wouldn't it be more correct that protons from a ligand split the...

03 August 2024 3,589 3 View

Why doesn't chromium 2+ ion use all its d-orbitals to receive lone pairs from six waters in [Cr(H20)6)]3+?

I'm guessing it's because the ligand experiences too much electron repulsion or proton repulsion from the chromium to insert them close to the 3d-orbitals which are close to the metal nucleus. Is...

03 August 2024 1,370 1 View

How can you draw a coordinate bond between a metal and donor atom in metal complexes, using discovery studio visulizer software?

Hello,, The metal complex ligand appears incomplete in the screen of the discovery studio visualizer

30 July 2024 3,354 1 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

How to determine the charge passing during a cyclic voltammetry?

Dear All, here is my question: if I have a 15-scans cyclic voltammetry performed with PalmSens, how can I obtain the charge passed during the process? Hopefully avoiding integrations,...

29 July 2024 3,733 5 View

AutoGrid and Autodock 4.2.6 window opens for 1 second then closes and there is no output files?

Good day, I am a student trying to work on Autodock for a project regarding Ligand-DNA interaction so i am quite new to molecular docking. i have followed tutorials and did all the steps...

28 July 2024 2,136 4 View

How can I use DFT-D3 correction ( Siesta version 5.0.1)?

Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...

27 July 2024 5,748 0 View

Why semicircle of nyquist plot is not complete?

While I am doing HER, I noticed that nyquist plots of Electrochemical Impedance Spectroscopy (EIS) is not complete. Will it affect for the Linear Sweep Voltametry (LSV) data? However, I can found...

26 July 2024 7,542 4 View

EDC carbodiimide and NHS easter 's half life among different pH?

It has been long known that EDC carbodiimide and NHS easter's half life agains hydrolysis are highly related to pH. However, very surprisingly, not yet found a paper giving a table/chart of their...

25 July 2024 8,738 0 View