In Plaxis we are using 2 types of modeling system 1, plane strain and 2 axisymmetric, .. which one presents a more reliable data..
Hello Dear Hossein
in plaxis i did not work axisymmetric model but in Abaqus you can do that and if you want we can do on your work with each other
i can model what you want and you write and do the other processes to be reach to a good paper.
Normally, during season changes, we have change in phreatic line, I wonder If anyone have information on its effect on the tunnel shield. Thanks
07 August 2016 6,208 0 View
06 July 2016 4,453 5 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
Source to get Impact factor of journals
01 March 2021 6,654 2 View
Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...
28 February 2021 400 1 View
There are many indexes when determining plant species: Plants of the World Online (POWO), International Plants Names Index (www.ipni.org), The Plant List (www.theplantlist.org) and others. But...
26 February 2021 3,404 10 View
Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks
24 February 2021 9,378 3 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...
24 February 2021 1,598 2 View
For a source to be considered reliable it must contain accurate historical information. But how does one determine the accuracy and reliability of sources in modern and recent history since not...
23 February 2021 1,346 13 View
Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...
23 February 2021 1,761 1 View
Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...
22 February 2021 4,882 3 View