Can we get a copy o the current status of this work?

Bob D Guenther @Bob_Guenther

01 January 1970 1 991 Report

In order for us to follow this work we need some additional info. We currently can find no published material

Avishag Gordon

Hi,

This project was published in the following source:

Intensive Care Medicine

July 2013, Volume 39, Issue 7, pp 1190–1206

Badges
Science topic

More Bob D Guenther's questions See All

I would like permission to use an image from this work in a textbook I am now preparing?

My book is an introduction to optics and will be published by Oxford. You can reach me via . email:[email protected]

01 January 1970 5,428 0 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to upload pdf of my articles published?

03 March 2021 2,183 3 View

Would adding books published in Lambert Publishers increase my RG impact?

There are some books published in LAP. Shall I add it to the RG?

02 March 2021 2,753 1 View

Is Journal of Agricultural Research a predator?

it is published by Juniper

28 February 2021 354 4 View

How can I publish a manuscript in free or low cost journal with good H-Index?

Dear all I am going to publish my manuscript which is from my thesis in a good H-Index journal but I found them very expensive(I don't have financial support) based on the exchange currency of my...

28 February 2021 7,800 6 View

Which software is better to write systematic review paper?

We have seen some authors use some software to write review paper. As obvious, the study of all published papers concerning our studying field is not possible and these software can help us to...

27 February 2021 6,296 1 View

Can I put a figure that was drawn by Bio-Render in publication paper?

I want to publish paper in journal but I have figures which have drawn with bio-renders, can I put them in the paper or which other software I can use to draw them?

27 February 2021 8,179 1 View

Can anyone please help me in processing SAR SLC data to generate interferogram using SNAP?

I have two scenes of the study area, one top and the other bottom. As per the tutorials and papers published, the step include coregistering the master sand slave images. However, when i try to...

24 February 2021 6,372 1 View

How do I change a preprint to published?

I want to know how to change the status of an article.

21 February 2021 1,536 2 View

How I can add publication with maiden name?

Good morning, can You please tell me how I can add an article that was published under my maiden name? When I try to add an article with this name, it appears information that I should be an...

21 February 2021 6,866 3 View