Why you do not use solid work2014?

is "solid work2014" suitable for dynamic analysis???

this software have any options for clearance joint???

this software allow you to make a simulation of the joint with your real data then you can analysis the presure or the other thing which is in this sofware. but this software is not sport software so it can not do clearance directly, if you a bit play with it then you find the undirect way.

on the other hand the other special software of sport biomechanic can help you in this case.

thanks alot for your answer

do you know the name of a special 

Dear mojtaba,

you can easily model this 4bar linkage in adams and measure it's kinematics and kinetics parameters, if you got any problems with this i can help you out in this.

and also there's a paper i hope it helps you out in your way:

http://www.sciencedirect.com/science/article/pii/S0094114X99000191

Check SAM from ARTAS, maybe have the option for joint clearance

You can have excact model with mkdelling software and insert to adams woth its clearance. 

Also msc visual nastran desktop 4 d have clearance.

Tow ways I know;

1. Designing in Solidwork and import to ADAMS and then define a contact between the pin attached to one link and the hole of the other.

2. Modeling the mechanism in ADAMS itself and define a contact between journal and the bearing.

Two ways, sorry

Dear Salahshoor

thanks alot ...

Dear Mr. Varedi

you are welcome.

You can model the revolute joint by establishing a dynamics model using FORTRAN or matlab programing language. You can also do re-development by the interface in the ADAMS.

Have you tried pro E or NX 11