Can R-R interaction in orthoferrites become predominant with high rare earth concentration and what is the effect of high temperature?

03 May 2017 1 963 Report

Many articles states about three interactions (Fe-Fe, Fe-R, and R-R) in orthoferrites either at or below Neel Temperature. Not many evidence were found regarding the predominant interactions at high temperatures and interaction with respect to rare earth concentrations. What will be the effect on the interactions at high rare earth concentrations and at high temperature?

Bartlomiej Andrzejewski

In orthoferrites dominant are Fe-Fe interactions. Even at high concentration rare earth moments can order at very low temperature (usually below 10K) and thus contribute to magnetic properties.

Best regards, Bartek

Badges
Science topic

More Sunayan Deka's questions See All

What is the temperature pressure profile for a methanol water mixture?

I have a methanol-water mixture and I want to know how temperature changes pressure with varying methanol-water percentage (v/v)?

23 November 2020 1,585 1 View

How to use constraint in Rietveld refinement?

I am working on spinel ferrites (AB2O4). Since cations in spinels can occupy both tetrahedral and octhedral sites, I need to find out the amount of cations occupying the tetrahedral and octahedral...

28 June 2020 3,677 1 View

How to use more than one instrument driver in a single labVIEW task to measure input vs output curve?

I am trying to measure magnetostrictive strain as a function of applied DC magnetic field. For this, I am using NI9237 module sitting on a chassis for strain measurement, and a lakeshore 425...

29 January 2020 2,862 3 View

How is the magnetoelectric current measured?

Measurement of magnetoelectric current (density) seems to be very popular to investigate the magneto-electric response of multiferroics. It'll be grateful to know how it is measured and about the...

11 June 2019 5,869 1 View

How to determine the r1, r2 values of dual mode MRI contrast agent when T1, T2 relaxations are for two different compounds (sample is composite)?

I have developed a nanocomposite of two different systems. Individually, one of the systems is a good T1 contrast agent and the other is a good T2 contrast agent. Interestingly, both of them...

17 November 2017 391 3 View

How to carry out STL decomposition in matlab for daily climate data? If I want to LOESS algorithm, then how to know what parameters to be used?

I need this to remove seasonality from the historical daily data in order to forecast daily values for the future period.

08 August 2017 6,116 1 View

How the value of surface layer (skin) capacitance of a crystal differs from that of grain boundaries and grains?

It is reported that several important pervoskites like SrTiO3, BaTiO3 have surface layers that are structurally different from the interior of crystal. Further, it can show transition similar to...

25 August 2016 1,036 7 View

How do I get the topology data (and parameter) for alpha-ketoglutarate (AKG) and any other modified nitrogenous base?

Hello! I have just started NAMD to run some simulation. Going through the tutorials i find that for generation of a PSF file I need to call a specific topology file. I have found various such...

20 June 2016 9,847 3 View

Can the loss peak shift towards the lower frequency side with increase in temperatutre?

I have measured the frequency variation of Z" at different temperature above the room temperature and observed a peak in Z" spectrum. Generally, frequency corresponding to the maximum of Z" i.e.,...

31 May 2016 9,130 2 View

Which simulation tool can be used to simulate a user-authentication protocol in cloud computing environment?

Which simulation tool can be used to compare different customized user authentication protocols for cloud?

09 March 2016 4,025 1 View

Physics: Why do we describe light by referring to its wavelength, but microwaves and radar pulses by referring to their frequency?

In physics, the description of the properties of light generally refers to its wavelength (nm), while in the range of microwaves and radio waves we refer to the frequency of a signal (e.g. kHz or...

03 March 2021 1,682 3 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Could you recommend any books about Number Theory?

Beginner level books. High level books. Analytical Number Theory. Algebraic Number Theory. Combinatorical Number Theory. Books about partitions. Books about primes.

03 March 2021 7,174 5 View

Can we classify HV and LV lines based on line length?

I have dataset which shows the length of power lines. I need to classify the lines based on the line length. Is there a rule to classify the High voltage (HV) and low voltage (LV) lines based on...

03 March 2021 4,116 4 View

Is there a classification scheme for rock cavities or caverns with respect to their size and shape?

The range of forms and sizes of cavities in rock is very big. Is there a classification scheme for rock cavities regarding their size and shape?

02 March 2021 4,511 3 View

Arena simulation - how do i model the following model in ARENA (see description) (new to ARENA)?

Hello, I'm fairly new to ARENA and I have the following problem: I have two queues in which, in each queue, a different order type arrives (both having an arrival rate of exponential 10). Order...

02 March 2021 2,431 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

Why almost every element would be metallized in sufficiently high pressure and low temperature?

(This statement is from wikipedia, BTW). What is so special about metallic bond that is limiting high-P low-T state of a matter (as long as individual atoms exist, not white dwarf of neutron star...

02 March 2021 3,309 2 View

Is there a powerful system for the security of the systems distributed on IoT systems?

02 March 2021 3,858 10 View

Which is suitable for use with Python? MySQL or SQL Server?

Which is suitable for use with Python? MySQL or SQL Server? What is your suggestion?

01 March 2021 3,422 3 View