I am wondering, can dilute solution of single compound (uM) form dimers, trimers, polymers, aggregates due to available sites for H-bonding.
Yes, for example the hydrolysis of Fe(III), Co(III), etc
yes.
it can be as well from keesom interaction for zwitterion
Thanks for your response!
I appreciate if you send me a reference.
Also, can dimers or polymers exist in solid form??!!
Hi, I am wondering what are the files that should be prepared? how? commands? that enables me to perform MD simulations using AMBER on Supercomputer.
11 December 2019 5,978 5 View
I want to find a database in which i can draw the chemical structure of the core ring and it will give me all the published structures with their biological activity. For example, the...
05 June 2018 1,191 11 View
I'm wondering how i can find an updated list of FDA-approved drugs for example, proton pump inhibitors, Topoisomerase inhibitors or whatever category.
04 May 2018 4,914 5 View
I'm wondering if you could suggest highly viscous solvent which is non-polar or slightly polar and can't form H-bond interactions. Most preferrably: a glass forming solvent at low temperatures to...
04 May 2018 3,493 4 View
I'm also wondering is this ranking standard or it differs from website to another.
02 March 2018 6,806 7 View
I hope you can help in these matters. 1) What is the difference between sequence and structural comparison between proteins? 2) Which website or software is good to use to perform this task? 3)...
10 November 2017 9,633 5 View
08 September 2017 2,553 13 View
From scientific point of view, if a h-bond is formed as in RN-H.....NAr The covalently bound proton can transfer to other side forming RN.....HN+Ar if it can take place, is there a reference for...
07 August 2017 9,998 6 View
07 August 2017 4,999 3 View
In Synchronous spectrum, both Exc and Fl monochromators are scanned simultaneously. MY questions are; 1) How to determine delta wavelength 2) if delta wavelength is 20nm, does it mean the data...
06 July 2017 4,018 4 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
effect of double bond on the flexibility of polymers
07 April 2021 0 0 View
I am writing to request some information for making polymer color flakes. I would appreciate the help.
17 March 2021 0 0 View
Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !
02 March 2021 5,785 3 View
It is oftentimes said to be a distinctive metallographic trait that differentiates a fully austenitic and a fully felly ferritic steel without etching that might distinguish between two. Why...
02 March 2021 728 2 View