Can Ferrite Core be used for chokes (inductors) for LC filters in 50/100 Hz rectified power line environment?

Can I simulate Ferrite in HFSS?

I have a design with 2 dipoles working at different frequencies joined in one system and separated by Ferrite. I think, Ferrite was used to minimize the interference between 2 antennas as much as...

25 January 2021 5,918 3 View

How do I know the parameters for calculating the dislocation (edge and screw) density from XRD?

Especially the C12, C44, and Ai values for ferrite pearlite microstructure. Thanks

19 January 2021 9,035 5 View

How to get mesoporous cobalt ferrite thin film on Pt/Si substrate by electrodeposition method?

We want to deposit a thin film of mesoporous cobalt ferrite using a surfactant on Pt coated Si substrate by electrodeposition. What is the procedure for it? Does KLE polymer useful for this procedure?

10 January 2021 467 10 View

Is there a generalized method to derive current-mode model of any DC-DC converters?

Hi all, As new DC-DC converters are being proposed, associated control method should be proposed and based on the small-model signal analysis of the DC-DC converters. Using average space state...

06 January 2021 7,247 3 View

Why mutual inductor takes high current at no load condition?

I simulate an inductive wireless power transfer system in matlab. I set the primary and secondary mutual inductor resistance is 0.3ohm. So when i run the circuit it took high current at no load...

29 December 2020 9,536 3 View

Simscape Linearization Error | frestimate(modelname,op,io,in) ?

Hello ! When tried to linearize the model for Bode plot in matlab getting the following error. In "frestimate(modelname,op,io,in)", it is required for each of the linearization input I/O...

08 December 2020 4,598 1 View

Why band gap energy of cobalt ferrites is increased with increased in zinc(dopinng element) concentration?

In most of cases band gap energy of cobalt ferrites is decreased with increase in Zinc concentration that is hold to brass model. But when energy band gape is increases with increased...

03 December 2020 2,439 3 View

How can calculate dielectric and electrical properties of nano ferrite powder form ?

How can calculate dielectric and electrical properties of nano ferrite powder form ? from powder form can we calculate electrical properties like dielectric resistivity .

03 December 2020 3,671 4 View

Carbon takes interstitial position in ferrite or austenite phase. Does it goes on octahedral site or tetrahedral site?

There two types of voids i.e., tetrahedral and octahedral site. My question is at which site C atoms preferer to go in Fe for (ferrite phase) BCC structure and (austenite phase) FCC structure, and...

26 November 2020 8,263 4 View

Why the theoretical calculation of percentage atom varies from measured data from EDX study?

I am wondering why there is a variation in the theoretical atomic percentage in Ni-Cu ferrites and the percentage atom values found from EDX spectra. In the case of Fe and O, there exists this...

25 November 2020 2,470 3 View

Tony Maine

Yes, it can, but the resulting device will be much larger because the magnetic permeability of ferrite is less than that of modern iron alloys. Ferrite is used for high frequency components, not 50 Hz units.

Bhagirath Mankad

Thank you Tony. I had the doubt and you have confirmed it.

Bhupendra Desai

Costly, uneconomical, and larger in size for same capacity...

Thank you Bhupendrabhai...