What should be boundary condition on wave function in a continuous potential?

If the potential is a continuous function of x ,say V,(x)= - A ( exp(2|x|/a) -1) ,what should be boundary condition on wave function ? Further ,will it be correct to argue ,wave function and...

11 December 2020 6,617 4 View

How to calculate antibody titre in serum of vaccinated animal using Direct ELISA?

How to calculate antibody titre in serum of vaccinated animal using Direct ELISA? The OD values obtained at different dilution how to determine the cut off OD against which the antibody titre...

31 January 2020 909 4 View

DNA precipitation without ethanol?

Is there a way of precipitating DNA from water without using ethanol? for example, mixing DNA with glycogen and ammonium acetate and then spinning it long enough so the bound glycogen+dna would...

22 August 2019 5,501 6 View

What is the meaning of writting a comment on a published paper ?

When one writes a comment on a published paper , what is actually the intention of the commenting author ? To point out the mistakes or present complete solution . It is seen that very often...

25 February 2019 6,029 4 View

Multiple peaks of the same compound in LC-MS Analysis?

Dear All, I was analysing some MAAs (mycosporine amino acid like substance) samples. HPLC shows a single peak with RT 4 wavelength 333nm. so I thought it is a pure compounds. To know the mass of...

21 August 2018 9,698 3 View

Silicon atom types in Charmm36 ff?

Hi, I want to simulate a ligand containing Silicon atoms ( present in the aromatic form as well). I wanted to ask if anybody could let me know the presence of silicon atom types in Charmm36...

14 June 2018 4,648 3 View

Can I use PVP instead of Sodium acrylate for the synthesis of graphene oxide magnetite nanocomposites?

It says that sodium acrylate is used as a stabilizer and to improve solubility of the precursors. And without its presence the particles aggregate. Can I use PVP instead??

12 June 2017 7,979 3 View

How the score is optimized in multiple sequence alignment?

Can anybody guide how a perfect alignment is obtained or constructed which can be compared with balibase alignment with baliscore? If we consider total conserved column score then it is possible...

05 December 2016 6,817 1 View

Can you help in MATLAB for H=p^2 - x^4 +2ix on eigenvalues ?

Can you help me in eigenvalues calculation using MATLAB for H=p^2 - x^4+2ix ?

29 June 2016 5,501 2 View

Having two soil type (A, B) and extracting with either solvent C or solvent D. C-D value (recovery) is my interest. How to compare A, B on this?

07 June 2015 7,697 8 View

What is your perception on using visual analysis or quantitative approaches to evaluate data from single-case research designs (n of 1 trials)?

Results of single-case research designs (i.e., n-of-1 trials) are often evaluated by visually inspecting the time-series graph and computing quantitative indices. A question our research team is...

03 March 2021 687 1 View

Irradiation data for JAPAN?

Hi, Could you help me to get the latest (2019, 2020) solar resource data for a particular site in JAPAN? PV GIS and NSRDB data are not in reach to JAPAN, I'm looking for some other database for...

03 March 2021 961 3 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Is there a powerful system for the security of the systems distributed on IoT systems?

Is there a powerful system for the security of the systems distributed on IoT systems?

02 March 2021 3,858 10 View

How Relativistic effects is one reason for lanthanide contraction?

The Lanthanide contraction which is the decrease in ionic radii of the elements in the lanthanide series from atomic number 57, lanthanum, to 71, lutetium, is due to poor shielding of the 4f...

01 March 2021 2,272 4 View

Is there a deep reason for using the squared modulus of the wave function as the probability density of the existence of the particle?

I think we were all surprised at the first time we got to know quantum mechanics that the squared modulus of the wave function is the probability density of the existence of the particle? The role...

28 February 2021 6,282 9 View

For modelling epoxy-based matrices (in composites), which model in ABAQUS is the most suitable, Concrete damaged plasticity or Drucker-Prager model?

I am working on developing a micromechanical FE model for predicting kink-band formation in UD composites. To model matrix plasticity, which model, out of Concrete Damaged Plasticity and...

28 February 2021 5,415 1 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View