Can anybody suggest an experimental protocol for sustained release tablet of BCS Class I Drug with natural polymers?

More Vaibhav Shukla's questions See All

Seeking Advice on Viability and Execution of Undergraduate Thesis Topic?

Hello everyone, I am currently developing a thesis proposal and would appreciate your input on its viability and how to effectively carry it out. My proposed topic is: "Does the perceived threat...

10 August 2024 8,992 0 View

To perform transfection with DharmaFECT Duo in AGS cells. Could you tell me what the ideal concentration is to avoid significant cytotoxicity?

I would like to perform transfection with the reagent DharmaFECT Duo (Horizon) on the AGS cell line. Could you please inform me of the optimal concentration to use without causing cytotoxicity in...

03 August 2024 3,851 1 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

What is Random Audit?

HI there, I've came across several articles discuss about random audit an Non random to tax evasion or compliance. Most of the articles is relating about effect of audit (random or non random)...

31 July 2024 5,309 7 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Why Powder XRD is performed after cruhsing a crystal if Single Crystal XRD analysis of the same crystal has been performed already ?

What information we can get from PXRD analysis other than from SCXRD analysis of a crystal ?

30 July 2024 6,261 4 View

How we can use lattice-based cryptography for construction of S boxes?

Please suggest basic literature on lattice-based cryptography. A kind response from the cryptographic community will be highly appreciated.

24 July 2024 6,291 4 View

I am working on III-V based tandem solar cells.Can anyone explain that solar cells work under forward or reverse biased conditions?

I want to know that n-doped side of solar cell is connected with positive or negative electrode.

20 July 2024 1,348 2 View

Can it is possible to find the cleaved sequence when a protein cleaved by a heamaglutanin protease (HA/P) by any bioinformatics tools?

Bioinformatics tools like peptide cutter

15 July 2024 6,453 1 View

Hello, does anyone know how I can get coordinates of two specific points on a moving body in Abaqus when applying a vdload subroutine?

Hello I am trying to simulate repulsive force of two permanent magnets in Abaqus. I have implemented Force equations into a vdload subroutine. sensitive parameters are the center to center...

15 July 2024 3,491 0 View

The Bigger You Are, the Harder You Fall (some lessons from Dinosaurs)?

Evolutionary fitness is based on an organism’s ability to adapt rapidly to changing environmental circumstances. Large-bodied mammals have been equipped with large brains (and hence a high...

06 August 2024 4,849 2 View

Are air moisture harvesting technologies effective in combating desertification?

Air moisture harvesting Air water collection devices

06 August 2024 5,473 2 View

How to isolate lymphocytes from mouse spleen?

I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...

04 August 2024 9,913 7 View

Polymer wear calculation?

What is the method for analytically calculating the wear and service life of polymer-polymer sliding pairs?

04 August 2024 1,078 1 View

State of art in natural disasters?

Are increasing the costs of disasters in the affected countries.

01 August 2024 1,794 2 View

How can I get my Granzyme B flow cytometry stain to be consistent?

I have used PE and PE-Dazzle 594 fluorochromes and have managed to get NK cells to properly show GranzymeB expression after 4 hr PMA/ionomycin stimulaton, but for some reason my CD8 cells in the...

01 August 2024 7,677 2 View

Posthoc test lettering in JAMOVI?

Does anyone know of a module for the JAMOVI software that is capable of generating mean separations using the classic letters based on post hoc results (e.g., Tukey test)? If, as I believe, such...

31 July 2024 3,333 4 View

What are the roles of innovation in achieving the Sustainable Development Goals (SDG)?

31 July 2024 3,533 2 View

What are the steps of formulating a herbal extract into a sheep/goat drench?

I am working on natural remedies for de-worming in small ruminant livestocks. Part of my project involves formulation of drench-type product, which I have not much experience in. My experience is...

30 July 2024 9,806 1 View

How to explain the different interaction between soluble and insoluble polymer in water?

Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.

29 July 2024 6,350 3 View

Mohamed A. Mekewi

Dear Vaibhav,

Try starches and do not forget to attach through covalency bonding and not through simple doping. Work on the amylose portion of the starch.

Best regards

Hassan Reza

For BCS class one drugs ..... first select the one available with low dose ..... then go for its half life....... half life be between 2 to 6 hrs select off ...... look for the required loading dose and maintenance dose after that select any natural polymer depending upon its compatibility.

Vaibhav Shukla

Thank you sir