I am using fuzzy concepts to improve one of the routing protocols. I have designed the algorithm too, but is not able to verify my algorithm as i don't know how to simulate my logic in NS-2.
Can any one tell me how to simulate my work in NS-2?
Hello All Kindly let me know that how I can obtain or Input GPS coordinates for moving nodes in our network in NS-3?
04 May 2017 807 7 View
Does two eNBs in LTE networks communicate using wireless medium or wired medium?
02 March 2017 6,583 3 View
06 July 2016 1,848 7 View
hello everyone Can you guide me that how we can configure any node in NS-2.34 as a WimAX node and how v can configure any node as a cellular tower?
05 June 2016 6,449 3 View
I mean which addresses are used for sending messages, logical or physical? how vehicles are identified uniquely? I am having confusion ,please clear my doubts?
04 May 2016 4,738 4 View
cellular technology
04 May 2016 5,375 0 View
Dear Friends I have downloaded a patch for GPSR ( a position based routing protocol) from internet , but i m unable to open it on NS-2.34. Kindly help me in providing the patch for GPSR which...
09 October 2015 9,299 0 View
I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...
03 March 2021 1,931 5 View
Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...
01 March 2021 9,332 6 View
Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...
28 February 2021 400 1 View
Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks
24 February 2021 9,378 3 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...
24 February 2021 1,598 2 View
Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...
23 February 2021 1,761 1 View
Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...
22 February 2021 4,882 3 View
For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...
21 February 2021 7,624 3 View
Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...
21 February 2021 2,333 4 View