Alternative / renewable energy implemented in Architecture and Urban Planning?

06 July 2016 5,100 4 View

How can I use a composite material/ carbon fiber in retrofitting/rehabilitation of steel columns?

The theory of retrofitting steel structure with composite materials/Carbon fiber, the material characteristic, the advantages or disadvantages that we can get. Any idea/document that may help....

01 February 2015 9,411 7 View

How to programme damage structure or a crack using matlab ?

Modelization using MATLAB is quite powerful, can I simulate a damage structure by removing an element and run the analysis? But if I would like to simulate an actual crack, any ideas?

01 February 2015 3,157 8 View

What's the difference between, deterministic and probabilistic methods ? So the semi-probabilistic and probabilistic ?

31 December 2014 9,683 3 View

International Conference of Steel Construction and Mixed at Tlemcen, on 12th and 13th October 2015, would anyone be interested ?

31 December 2014 5,388 0 View

Is anyone familiar with dynamic simulations using newmark in Matlab ?

How can I apply the newmark method for a bridge truss using Matlab the simplest way (I'm a beginner ,don't have much skills in matlab) ?

31 December 2014 2,521 6 View

How can I measure a reliability index for civil engineering structures?

31 December 2014 5,973 12 View

Is anyone familiar with the reinforcement of a steel beam ?

If a beam is damaged, corroded or cracked, how could be reinforced ?

31 December 2014 1,945 9 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

Is it possible to set a breakpoint at a specific DYNAMIC instruction using the GNU Debugger (GDB)?

Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...

24 February 2021 1,598 2 View

Langevin Dynamics in shear flow?

Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...

23 February 2021 1,761 1 View

Should I use Pressure Based Solver or a Density-Based Solver?

Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...

22 February 2021 4,882 3 View

How to simulate 5G Quality of Service characteristics?

For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...

21 February 2021 7,624 3 View

Open Source IoT Simulators supported by Machine Learning?

Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...

21 February 2021 2,333 4 View

How can I simulate the optical absorption spectrum of a biomaterial (like DNA or protein) in COMSOL?

I need to simulate the optical properties of a biomaterial, namely DNA, in COMSOL. Basically I need to simulate the IR absorption spectrum of a cylinder filled with a 'concentration' of DNA. I am...

21 February 2021 3,043 3 View