Dear all,

I am new user of swat cup, I solved all the problems of executable, timing...

I turned successfully the project with 1 variable (flow out) and when adding another variable (ET) it did n't work there was errors.

I am sure about the observed input data but I am not sure about the structure of the swat cup project is it ok or no?

Please could you check if the structure and the input data introduction is correct manly with 2 variables? ; and then should I after calibrating with flow_out should I deleating all the parameters influincing the runoff and giving only the parameters influencing the ET or keep all of them?

thank you so much