"Styrax japonicus" or "Styrax japonica"?

08 September 2017 157 0 View

Where to find "the" correct latin plant name?

01 January 1970 3,991 0 View

What is your perception on using visual analysis or quantitative approaches to evaluate data from single-case research designs (n of 1 trials)?

Results of single-case research designs (i.e., n-of-1 trials) are often evaluated by visually inspecting the time-series graph and computing quantitative indices. A question our research team is...

03 March 2021 687 1 View

How to address this issue in the analysis of Real-Time PCR results?

To dear Researchers, I was analyzing a series of concentration for estimation of Real-Time PCR efficiency. The concentration was 1:10. I used MS-excel to evaluate Slope. The result of slope was -8...

01 March 2021 8,683 4 View

Can I download BibExcel for MacOs?

Hi everyone, I would like to ask how I can download BibExcel software for MacOs? There are some links which are supported by Windows but I could not find it for Mac. or is there any other software...

01 March 2021 652 1 View

Compact antenna for the frequency range 1 MHz-5 MHz?

Hello everybody! I have a problem with developing a compact antenna for the 1MHz-5MHz frequency range. Tell me what type of antenna can be used and what books and articles to read to perform this...

27 February 2021 7,710 4 View

Can impedance of antenna be less than 50 ohms?

I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...

27 February 2021 4,218 7 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

How to approach CFD simulation results of a flow past a cylinder?

Hi all, I'm doing a transient simulation of flow past a rectangular cylinder close to the free surface. As far as I'm concerned, the common practice is to discard the initial stages of the...

25 February 2021 1,348 3 View

Anyone with some Transgenomic Wavemaker software? Seeking help from the chromatography community?

I am trying to seek out some Transgenomic Wavemaker software (happy to purchase a computer too) to operate a fraction collector. The only way to connect to the fraction collector so far is to...

23 February 2021 9,181 1 View

Best excel chart to compare algorithms' running time?

Hi I want to compare the running time of robotic path planning algorithms. The grid size is 8X8. I have 100 scenarios of start and goal positions.. Each scenario is run in three obstacles ratio...

22 February 2021 621 1 View

How to generate AA6061 alloy or any aluminium alloy crystal in material studio?

I need to carry out molecular dynamics simulation on Aluminium alloy. For this i need the crystal structure that which could be further replicated to form a structure.

22 February 2021 1,410 1 View