How to do mono formylation of N,N-diethyl-3-methoxybenzamide?

I have attempted the formylation of the above mentioned compound using a very well reported protocol using secondary Butyl Lithium and TMEDA at - 78 degrees Celsius. I have done it quite a few...

08 February 2021 2,793 2 View

What is the minimum number of cells required for fluorescence in situ hybridization?

I have to perform a FISH experiment with limited number of cells and I am trying to estimate the minimum number of cells required to do FISH. Cells are from mammalian cell line. I failed in doing...

12 January 2021 7,887 1 View

Can you give me some Information about the generation of ROS in marine surface water?

Reactive oxygen species is a very new term i think

23 December 2020 8,416 4 View

Can someone suggest me a wear detection method for a pipe which goes under intense heat and pressure at intervals?

I am looking for a wear detection method for a pipe that goes under intense heat and pressure for short instances at intervals. this process has an average cooldown time of 8 seconds between each...

08 October 2020 3,776 2 View

Single-cell cloning from SkBr3?

Did anyone tried single-cell cloning from SkBr3 cell line. I am failing in growing cells post single cell seeding in wells. Any help is appreciated

27 September 2020 8,762 4 View

What to do when RT PCR becomes positive again after 15-20 days of 1st sample positivity?

We are getting some patients who were initially positive of RT PCR for Covid. But in retesting after 15-20 days or even 20 days after those patients remain still positive. Is it for dead RNA...

17 August 2020 9,552 9 View

How to calculate % sequence identity using Clustal W?

I am calculating % epitope conservation for different mammalian antibodies against zebrafish. I have performed the Clustal W for antigenic peptide used in raising the antibodies against the...

05 August 2020 6,399 5 View

What is the Source of Harmonic Power ?

Consider a sinusoidal supply at fundamental frequency as shown, with a series inductive reactance leading to a bus. Let a diode rectifier load be connected to the bus. The switch Sw for resistive...

24 June 2020 8,175 27 View

What is the best book on Game theory from the perspective of Computer Science and Engineering?

I do not know much about game theory. I am finding a book where different protocols and algorithms of computer science have been analyzed using the concept of game theory.

17 May 2020 4,774 7 View

How can a PhD in interdisciplinary fields can benefit a researcher in job market?

I am a PhD scholar of Humanities and my research is broadly connected to Anthropological studies and framework. I have also published with an Anthropological journal of global repute and looking...

10 May 2020 4,202 1 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Which is a lucid standard comprehensive book to guide on psychological scale construction and its standardization?

02 March 2021 7,082 3 View

LOAD DISPLACEMENT CURVES Stiffness increasing in ANSYS non linear analysis. HOW CAN I CORRECT IT?

Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...

01 March 2021 9,911 3 View

How to accurately quantify chitin?

Hi all, I have been working on the quantification of chitin in insect samples and feed for a while but I can notice that the quantification methods (e.g. exposure to HCl, NaOH, and weighing sample...

01 March 2021 1,843 2 View

What is recommended for solid domain in ANSYS FLUENT?

Should I mesh the solid domain ? or should I use wall thickness? or Shell conduction? for Heat Transfer between two fluids of a Heat Exchanger. what is recommended?

01 March 2021 9,785 3 View

Can someone suggest a way to prepare slides to observe under confocal microscope for observing fluorescent tagged proteins??

I am growing the cells on coverslips and transfecting the fluorescent tagged protein directly on them. Then i want to observe these cells under confocal microscope. Currently i am just using...

01 March 2021 6,142 3 View

How to choose ANN number of hidden layers and nodes?

Hello, Could you please share any interesting research explaining how to choose the number of hidden layers and nodes per layer in case of regression problems using ANN? Thank you, any help would...

01 March 2021 6,200 3 View

How can i resolve the "final solutuin is not converged" error in Comsol for my heat transfer simulation??

I have been trying to simulate heat transfer problem in Comsol 5.5 for long time but it always throw an error stating: "Failed to find a solution. Maximum number of Newton iterations...

28 February 2021 8,626 3 View

PUC19 as a transfer plasmid for lentiviral delivery?

Hello, Is it possible to use pUC19 as a transfer vector to be packed in using the second generation viral particles packaging system( pMD2.G; psPAX2 plasmids)? As far as I understand it there is...

28 February 2021 4,868 2 View