Hello everyone !!!!
I am modeling a cold formed steel profile in the ABAQUS program. I need to insert a non-uniform load into the structure section. Skew bending moments are applied at the two end sections by means of sets of nodal concentrated forces statically equivalent to 1 kNcm, as shown in the attached figure.
Are there any predefined options in the ABAQUS system to insert a linear stress on the edges?
How can I do this in ABAQUS? Anyone has a solution.
Please note that, according to the de Saint-Venant principle, ths actual stress distribution on the cross section is irrelevant at some distance away from that section, and only the resultant matters (force, monent).
You can use Load>Create...>Pressure: Distribution - f(x), Type - Expression field
For example: 100*Y.
- Badges
- Science topic
- Similar topics
- Force