I have tried to use a green method to make silver nanowires, problem is when I used AgNO3 crystals despite my best efforts I stained my labs bench and left a few black marks on my hands from when I was handling it. Ok we could say in small doses that is ok and also that it does only is absorbed on the top layer of dead skin, the problem is though that I want to avoid this risk. Are there any ?

It would not be nice for my team if I made a mess again so trying to make sure I don't cause problems for anyone.

Every MSDS sheet I read says AgCl or AgNO3 etc. precursor is corrosive.

Any tips?

Harry

More Charalambos Andrew Georgiou's questions See All
Similar questions and discussions