04 January 2022 0 3K Report

This question as well as other interesting problems are addressed in the attached paper.

More Frank J Hall's questions See All
Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How are Large Models Exploring and Outputting Knowledge Understanding in Specific Content Areas, and What Does Academic Research Say About It?

Hello everyone！ I am currently exploring the performance of large models in understanding knowledge in specific domains, and attempting to construct a knowledge framework similar to what...

05 August 2024 5,729 2 View

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity?

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...

03 August 2024 5,358 0 View

How do i get an account to upload my published papers?

need to open an account to upload my published papers

01 August 2024 9,255 1 View

What is the problem with these tissue culture plants?

All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.

01 August 2024 589 4 View

How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,227 1 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

Which statistical test should we use?

N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.

30 July 2024 7,233 4 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

Can the limit of quantification (LOQ) of an analytical method fall outside its linear dynamic range, or must it always be within it?

Can an analytical method's limit of quantification (LOQ) be outside its linear dynamic range, or is it always required to be within it? Please provide a thorough explanation supported by verified...

29 July 2024 7,198 9 View

Similar questions and discussions
What is the maximum acceptable degradation of gain in the orthogonal plane relative to the beam scanning plane for beam steering antennas?

In research papers on beam steering antennas, while the radiation pattern for the beam scanning plane (such as the horizontal or vertical plane) is typically presented, details regarding the...

03 July 2024 8,321 0 View

How to converge PEMFC in Ansys Fluent?

I am simulating 1 cell of PEM with an area of 50 cm². The mesh has an orthogonality of 0.2 for the channels and bipoar plates (polyhedra) and a quality of 1 for the active zones (hexagonal). The...

26 June 2024 2,358 0 View

Why I am getting follwing error when I tried to open .dta file in SPSS25?

>Error # 7202.  Command name: GET STATA >Input dictionary read error. >Execution of this command stops. Cross Product Matrices are not supported

19 June 2024 5,423 0 View

ABAQUS - Face could not be partitioned. How to resolve this error?

I am doing orthogonal machining of aluminum in 2D. However, when partitioning for depth of cut with a sketch on face strategy with a parting line, it says that face could not be partitioned. How...

18 June 2024 8,000 0 View

Lifestyles and correlations in cultural tourism?

I am looking for resources in the Netherlands regarding cultural tourism. So what cultural activities correlate, and what lifestyles can be distinguished. Any resource is welcome, articles, factor...

27 May 2024 447 2 View

Why can off-diagonal cubic force constants be non-zero in VPT2?

So in the VPT2 treatment I get how we can expand the potential V along a normal coordinate q_i as: V = 1/2 k_ii * q_i^2 + 1/6 k_iii * q_i^3 + 1/24 k_iiii * q_i^4 and we get non-zero elements for...

22 May 2024 8,032 0 View

How to characterize the material parameters of pure epoxy matrices in an event of low velocity impact (LVI) simulation in abaqus?

I have two different epoxy matrices, in the events of low velocity impact (LVI) experiments, for a certain impact energy one matrix completely fractured and the other showed no visible damage in...

21 May 2024 5,065 0 View

Box's Test IN TWO WAY REPEATED MEASURE ANOVA?

If the Box's Test yields a significant p-value (p < .001), indicating unequal covariance matrices of (X) across (3 variables) between (2 groups), it raises concerns about the assumption of...

17 April 2024 1,234 4 View

Can SIMPER (vegan, R) analysis be done on binary distance matrices, particularly those containing ASV data?

Hello! I am trying to characterize communities of eukaryotes living in biofilms using V4 region 18s amplicon sequencing data. Working with this type of data is new to me, and very interesting!...

04 April 2024 6,603 1 View

Does the photon undergo a velocity torque, a temporal c that we know and it is parallel and another spatial and it is orthogonal we do not yet know?

If such a thing turns out to be correct any displacement at velocity v results in an orthogonal velocity affecting the proper time. Therefore time dilation increases because the proper time...

29 March 2024 5,611 0 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close