I am seeking for XRD PDF for AA5083 alloy
what is the correlation between the erosion resistance and depth of crater ( indentation) that resulted from single particle impact ( steel ball ) test at normal incidence ( in case of target is...
19 February 2018 6,714 2 View
Experimentally.. If the single particle impact (steel ball,d=.5 mm, v=15 m.s-1, impact angle=90) test performed on material before and after treatment. The obtained result was the depth crater of...
01 February 2018 7,386 0 View
why the values of corrosion rate for Al-alloy not the same when measured with different techniques ( immersion test - Electrochemical corrosion test
01 February 2018 2,235 6 View
01 February 2018 9,503 2 View
I mean what is the optimum homogenization temperature for AA5083 alloy
04 May 2016 9,029 5 View
I am seeking for PDF card number for Al6( Mn, Fe), so please anyone have the PDF code # for Al6 ( Mn, Fe ) advanced thanks
01 January 1970 3,318 0 View
Require for Rietveld refinement in XRD.
08 August 2024 3,081 2 View
Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...
07 August 2024 9,563 0 View
During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...
06 August 2024 726 3 View
I want to refine one XRD peak of my in-situ xrd but the background is never working good which ultimately fails the refinement. How to refine and adjust the background using GSAS-II
05 August 2024 5,291 2 View
How to calculate the molar proportions of the oxides from the XRF analyses?
02 August 2024 2,565 2 View
I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.
02 August 2024 6,789 4 View
How select composition for ods-high entropy alloys?
31 July 2024 2,795 1 View
What information we can get from PXRD analysis other than from SCXRD analysis of a crystal ?
30 July 2024 6,261 4 View
I will be doing an XRD on a sample which is powdered in natured and is a hydrogenated compound. I would like to know how we can understand the individual components and components by using the...
28 July 2024 4,548 2 View
Any suggestions with respect to etchant composition and holding time?
27 July 2024 6,925 2 View