ANSYS Explicit loads?

Hi I would like to apply loads in two steps in explicit dynamics as follows; 1. Apply vertical load without horizontal sliding 2. Then, with this load, apply an horizontal displacement Thank you

09 October 2017 6,596 2 View

How do we fitting of PSD data for AFM images?

When I have plotted PSD data and fitted with maybe Gaussian function, how do I relate the coefficients to the morphology of the samples?

06 July 2017 2,007 0 View

Explicit

In Explicit Dynamics of ANSYS, how can I apply a distance varying load and velocity?

05 June 2017 4,500 3 View

When undertaking AFM roughness, is there any model for sampling to determine the number of points and measurements to take?

I am characterizing thin films

03 April 2017 4,559 1 View

Are you asking Book chapter proposals?

Are you writing books? Are you calling for chapter proposals?

01 January 1970 5,784 1 View

error in running a model in Abaqus

Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1

17 August 2021 0 0 View

error in modelling model in Abaqus

Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1

17 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MGL tools

20 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

what is the simplest definition of ion exchange capacity

What this unit identifies for the ion exchange capacity ca. 0.92 meq. g-1. I am a newcomer in the membrane area. I just started. I highly appreciate your help

08 May 2021 0 0 View