Dear Adnan and Usman: 

ABAQUS documentations have  two volumes of tutorials. Moreover, pdf, ppp, in MS Word, and you-tube tutorials are also available on the Internet.. Creating part, assembly, processing, and post-processing with ABAQUS is than similar software packages ANSYS, SOLDWORDS, or Creo. Display your emails and I will email you some basic tutorials.

This is one of the links which i found, hope it helps:

http://rcc.its.psu.edu/resources/software/abaqus/ABAQUS_01_21_2011.pdf

I suggest to you the tutotial as exemple you can begin by the exemple "4.3 : connecting lug" int the guetting stated manual

Sir Muhammad Adnan, I have a common interest for learning ABAQUS, how should I contact you?

You can write me an email or call me

Dear Adnan and Usman: 

ABAQUS documentations have  two volumes of tutorials. Moreover, pdf, ppp, in MS Word, and you-tube tutorials are also available on the Internet.. Creating part, assembly, processing, and post-processing with ABAQUS is than similar software packages ANSYS, SOLDWORDS, or Creo. Display your emails and I will email you some basic tutorials.

@Umar Farooq ..Please mail me the documentation. My mail id is [email protected]

Umar Farooq , I am wondering if you can please send me the documentation pleas , [email protected]