Syed Tanzil Haider

5 Questions 1 Answers 0 Followers

Questions related from Syed Tanzil Haider

Can steel pin of the pin on disk tribometer setup be used in doing wear rate testing of sintered Alumina??

08 October 2019 3,972 6 View

What are the non destructive ways of measuring elastic modulus of ceramic pellet?

I have done spark plasma sintering of the ceramic powder and now i need to measure its elastic modulus , how can i do it without destroying the pellet. I have come to know about pulse echo...

20 July 2019 4,959 7 View

I have limited number of samples available for testing , can i use the same pellet sample of alumina to see under SEM that i used to measure density?

I am running low on number of samples, so can i use a single pellet for both density measurement by Archimedes and SEM analysis after drying it? SEM will done on the fractures surface of the pellet.

09 July 2019 6,182 6 View

Why black glassy phase is sintering in boriding(boronizng) of stainless steel in slurry salt bath consisting of borax, boric acid and ferro-silicon.?

Black glassy phase is sintering on test specimens on stainless steel ,which is sintered with the specimens and do not come off , so we are unable to observe iron boride coatings,kindly someone...

08 February 2016 9,115 4 View

Which material wires can I use in a high temperature environment in furnace up to 1100 deg Celcius temperature for hanging purpose of samples?

It should be inexpensive and easily available.Wire must not break when i pull the samples with it...

17 September 2015 1,136 0 View