Sandip Adhikari

11 Questions 14 Answers 0 Followers

Questions related from Sandip Adhikari

How can we obtain the moment-rotation curve for beam and column?

How can we obtain ''user-defined hinge properties'' i.e moment-rotation curve for column (P-M-M hinges) and beam (M- hinges) for a section of concrete beam and column?

28 August 2015 1,276 9 View

What are the contact parameters for ''Mohr-Coulomb criterion'' in the splitting and sliding failures between 3D surfaces ?

I am using CONTACT 173 and Target 170 for the 3D contact surfaces. In many researches i have studied that, coefficient of friction , contact cohesion and contact opening stiffness governs the mohr...

02 April 2015 6,498 3 View

How can we obtain these parameters?

Is there any formulas?

16 March 2015 3,980 5 View

Which type of contact options can be used between the interface of brick and mortar?

I have used CONTACT 173 and TARGET 170 element. The shear bond strength of brick-mortar is 0.005 MPa, coefficient of friction for bed joint is 1.2 and head joint is 0.85. Does it works if i use...

12 March 2015 1,977 3 View

Can we obtain an approximate stress strain curve of a material if its compressive strength is known?

I have a stress strain plot of a brick with a compressive strength 4 MPa. I also have a brick with compressive strength 10 MPa but no stress strain curve.Can we obtain it? What methods can be used?

24 February 2015 5,226 12 View

How can we adjust the contact behavior while modelling a masonry wall?

I am doing non-linear analysis on the shear behaviour of the masonry wall. I have used SOLID 65 element for the modelling of mortar and the brick. CONTACT 174 and TARGET 170 for the brick-mortar...

13 February 2015 2,650 8 View

How can we apply the monotonic and cyclic loading in ansys apdl?

I want to apply the loads in a masonry wall to check for the load-deflection curve.

10 February 2015 700 4 View

What is the problem shown in this analysis?

This is a model for a brick masonry wall. I used contact 174 and target 170 elements. I assigned from ''contact wizard ''.

25 November 2014 534 3 View

How can we assign ''element attributes'' after creating the volumes?

I have created a model that uses solid 45 and solid 65 elements, but I don't know how to assign the element attributes for the volumes. For some volumes I want to assign solid 45 and solid 65 for...

23 November 2014 6,570 3 View

Can anybody provide me the non-linear time history analysis in ANSYS 15?

I want to model a masonry structure for Non-linear analysis.

20 November 2014 8,882 2 View

Can we model masonry walls (Finite Element Modelling of brick,mortar and interface) in SAP 2000?

04 November 2014 451 3 View