Pramod Rai

4 Questions 4 Answers 0 Followers

Questions related from Pramod Rai

Why do some researchers consider "damage parameters" in concrete while others do not?

I have been reading a few papers related with the non-linear finite element analysis of RC beam under static loading, in Abaqus using CDP model. So far, I have found that some researchers use...

05 May 2019 5,808 4 View

How can I constrain translation but free rotational degrees of freedom between two 3-D solid surfaces in Abaqus?

As shown in the figure below, the problem has two parts: Part 2 goes throughout the part 1, creating a contact between two surfaces (highlighted in yellow). Both parts are 3-D solids. When an...

02 February 2019 5,150 10 View

How can I provide temperature Loading in Abaqus?

Consider a rebar with it's one fixed (like a cantilever). I am trying to perform this analysis in two step: First, I want to apply temperature loading (consider, total temperature change = 100...

11 November 2018 7,673 3 View

Are there any ways to provide constraint between a 3D-Solid node(or Surface) and a 2-node (truss or beam element) in ABAQUS?

Consider a rebar welded on a base plate and load is applied on the lateral direction. Can you suggest some ideas to constraint the end of the rebar with the base plate in ABAQUS ? The attached...

04 April 2018 4,367 3 View