Pankaj Munjal

6 Questions 9 Answers 0 Followers

Questions related from Pankaj Munjal

What is size effect and material variability aspects on compressive stress-strain behavior of burnt clay and concrete brick unit?

Is there any size effect and material variability aspects on the Compressive stress-strain response of burnt-clay brick and concrete brick units during the compressive strength test.

07 June 2018 5,651 5 View

What is the difference of compressive modulus and tensile modulus of ECC?

I have doubt regarding the compressive modulus and tensile modulus of ECC (Engineered Cementitious Composite). Is there any difference between these two modulus, or it will be same? Thank you.

26 October 2016 6,674 4 View

How to calculate the damage parameters (dc & dt) for damaged plasticity model in ABAQUS?

I have found two different formulae for calculating damage parameters (dc & dt) i.e. dc = 1- (σ/σmax) (Paper-1) dc = 1- Exp (-ac x εin) Can anyone please tell me which formula is correct for...

15 September 2016 3,977 3 View

How to remove compliance of the Hydraulic Actuator while calculation for deflection?

I have performed a four point flexural test of Concrete beam using Hydaulic Actuator system. The displacement was measured by the control systems (measured by the movement of Actuator). Now I have...

12 March 2016 2,730 1 View

How can I calculate the parameter fb0/fc0 for concrete damage plasticity in ABAQUS?

What is this parameter fb0/fc0 used while defining material properties of concrete damage plasticity model in ABAQUS. How we can calculate this parameter for our model. Thanks.

24 December 2015 5,049 4 View

In numerical analysis of FRP wrapping of column, which properties of FRP should we used either properties of FRP laminate or properties of dry fabric?

I am studying the numerical analysis of FRP wrapping of rectangular masonry column. In the numerical analysis, which properties (Tensile strength and Modulus) of FRP should we used either...

25 November 2015 545 6 View