Naveen Shirur

6 Questions 11 Answers 0 Followers

Questions related from Naveen Shirur

Arduino capacitive sensor without ground?

Hello, I am trying to implement capacitive sensor using Arduinio. It is a simple RC circuit. It works as follows, Concept --> Self capacitance of a single plate capacitor Only send pin and...

05 May 2019 5,785 7 View

Result of Ansys Fluent 3D Symmetrical Simulations shuld be Multiplied?

Hello, I have carried out 3D symmetrical simulations in Ansys fluent. It is a 3D 20 degree rotated model. I created planes at different locations. Forces on these planes should be multiplied to...

03 March 2019 2,210 2 View

Problem with Redlich Kwong Real Gas Model at 100 Mpa?

Hello, I am simulating flow between two containers with a pressure difference of 100Mpa. (Volumes: 1L 100Mpa and 200L 1bar) connected by a pipe of diameter 11mm. Simulation works with ideal gas,...

01 January 2019 4,950 4 View

How to model gas flow between two containers in Ansys Fluent?

Hello there, I have two questions in this area, 1. How to avoid the probelm ''Excessive temperature change in Fluent. I am unable to understand the cause for this error. When Hybrid Initilization...

06 June 2018 7,732 4 View

Ansys Fluent : Inlet mass flow rate problem?

Hello, I am simulating a gas nozzle and when i specify pressure inlet and compute initial mass flow rate it is totally incomparablw with hand calculations. Theoretical mass flow rate shows nearly...

06 June 2018 4,491 7 View

What is difference between Orifice exit temperature and downstream entry temperature in Simscape gas model?

Hello, I am trying to model gas flow between two tanks using orifice and tool used is Simscape. I observed the exit temperature of orifice restriction and entry temperature to downstream are not...

04 April 2018 6,370 3 View