6 Questions 11 Answers 0 Followers
Questions related from Naveen Shirur
Hello, I am simulating gas flow from a high-pressure (700 bar) to a low-pressure container as shown in the attached figure. The red curve shows the pressure curve obtained from the testing, while...
05 July 2020 2,211 2 View
Hello, I am running a 3D density based transient problem with Spalart-Allmaras turbulence model. After few iterations I am getting Negative Nut in xxx cells. I tried to search the cause, but not...
05 June 2020 3,294 1 View
Hello, I went through ansys fluent dynamic meshing guide. It says remeshing can be done only on tetrahedral mesh. I still tried to implement it on hexahedralmesh. It works well. It is bit...
04 May 2020 2,841 4 View
Hello, I am trying to implement capacitive sensor using Arduinio. It is a simple RC circuit. It works as follows, Concept --> Self capacitance of a single plate capacitor Only send pin and...
28 May 2019 6,358 7 View
Hello, I have carried out 3D symmetrical simulations in Ansys fluent. It is a 3D 20 degree rotated model. I created planes at different locations. Forces on these planes should be multiplied to...
25 March 2019 4,233 2 View
I am interested in knowing if there is any method to measure the eigenfrequency of very small object of size 5mm x 5mm x 3mm. Material is an elastomer. The problem associated with this is material...
18 May 2015 8,894 7 View