6 Questions 10 Answers 0 Followers
Questions related from Muhamad Zulhasif bin Mokhtar
Hi, I observed low device performance of perovskite solar cell if the temperature of the samples is raised above 60 °C during the gold evaporation. Which boat (type of boat, thickness, width,...
20 July 2018 3,165 5 View
Sorry I am not a chemist, but need a simple (references or explanation) about what is the advantage(and disadvantage) of choosing DMSO or DMF when fabricating a perovskite solar cell. It is known...
27 November 2017 6,601 13 View
If I construct two PSCs 1)MAPbI3 and MAPbI3-yBry based on common configuration FTO/bl-TiO2/mp-TiO2/perovskite/Spiro-MEOTAD/Au, which one will give higher hysteresis? and why? Any reference(s)? Thanks!
22 October 2017 7,888 3 View
I fabricated different band gaps CH3NH3PbIxBr3-x active layers on mesoscopic NIP junction (FTO/bl-TiO2/mp-TiO2/CH3NH3PbIxBr3-x/spiro-MeOTAD/Au) and I found that Voc is increased as Eg become...
29 July 2017 6,379 7 View
Why most of the people used FTO instead of ITO for perovskite solar cell fabrication? I know the band gap of ITO and FTO is 4.9eV and 4.4eV respectively, but is this will make any different?
08 March 2017 7,812 4 View
What caused the perovskite solar cell to have a low Voc? I know that poor cells exhibit low FF due to pinholes presence on the light absorbing layer, causing the short circuit between gold...
03 March 2017 1,463 3 View
