Mohammadreza Maleki

11 Questions 14 Answers 0 Followers

Questions related from Mohammadreza Maleki

How much is the lift coefficients for the shear gradient force and the wall interaction force of NACA0030?

I need lift coefficients of NACA 0030 for simulate DLD microfluidic behavior in cell separation.

11 March 2024 9,773 0 View

How can I simulate DLD microfluidics in comsol?

How can I simulate laminar flow and particle tracing for DLD microfluidics in Comsol multiphysics?

17 October 2023 4,268 1 View

How can I determine the Length and width of the DLD Microfluidic?

I`m designing an Integrated microfluidic containing two DLDs, how can I determine the Length and width of the DLD Microfluidic? Are there any equations to calculate the Length and width of the DLD...

10 October 2023 4,956 0 View

What is the new research areas based on microfluidic systems for Testicular Sperm Extraction?

I`m a Ph. D student of mechanical engineering and I need a subject for PHD thesis based on microfluidic systems for testicular sperm extraction. Can anyone guide me and provide me with a topic?

06 February 2023 7,302 0 View

How to prevent rancidity of coolant?

In a production line of a factory, various machining stations use Z1 coolant. The factory is in a tropical area where the ambient air temperature reaches 50 degrees Celsius. The heavy volume of...

10 July 2022 7,021 0 View

How much are density, dynamic viscosity, thermal conductivity, heat capacity at constant pressure, and ratio of specific heats of Human Tubal Fluid ?

I need to simulating rheotaxis and terotaxis behavior of sperm in a microfluidic channel by comsol application. My medium liquid is Human Tubal Fluid (HTF) and I don't have any data about its...

31 August 2021 8,018 2 View

Which gases exit from brick kilns?

I want to design and fabricate a filtration system for the brick kilns of a factory. But I don`t know which gases exit from brick kilns. Are there any data or articles related to this subject?...

24 February 2021 7,236 3 View

What kind of amides does the tendon consist of?

In visible reflectance spectroscopy performed on a bovine tendon, peaks were observed corresponding to tendon amides. But I do not know these peaks are related to what kind of amides.

17 August 2020 4,623 3 View

How much is the temperature of direct reduced iron?

Some references have mentioned that the direct reduced iron temperature is between 800 and 1200 ° C. But I need accurate temperature for design and build a dust filter for the dust collector system.

04 December 2019 6,926 5 View

What is the best biocompatible adhesive for paste optical fiber to metal?

I want to insert a metal probe into the body. This probe is a metal enclosure that contain of an optical fiber. The light comes out of the fiber end and through the hole in the end of the tube. I...

28 October 2019 8,783 5 View

How I can coupling laser diode light into the optical fiber without dissipation?

I need to coupling a 250mW laser diode source light into a 1.5 mm multi mode optical fiber. I have done it with a double convex lens. But, I have a lot of dissipation! How I can coupling laser...

21 October 2019 9,388 12 View