5 Questions 1 Answers 0 Followers
Questions related from Minhajul Bari Prince
I am conducting a pushover analysis of a 2D frame using varying rebar grades (400, 500, and 600 MPa). I use P-M2-M3 hinges in columns. The analysis was completed for all cases. However, it showed...
15 October 2024 9,736 0 View
I have modeled masonry infill in the following manner by a simplified modeling approach, shown in the attached picture. However, I faced low-capacity issues. When I ran the analysis with the bare...
08 April 2024 4,982 1 View
I am attempting a numerical modeling of a pullout test for reinforced concrete. I have calculated the stiffness parameters following the FIB 2010 standard. I used cohesive contact interaction...
30 October 2023 8,612 2 View
I want to use sma-based reinforcement at the particular face in the beam and column. Moreover, is it possible to use typical steel reinforcement and sma-based reinforcement in the same section of...
30 July 2023 8,884 2 View
Hi, Can anyone give me a source where I can find detailed steps in modelling of negative stiffness isolator? Another question is, Can I use shape memory alloy as material of base isolators in...
12 May 2023 6,913 2 View
