H. M.A. Mahzuz

11 Questions 13 Answers 0 Followers

Questions related from H. M.A. Mahzuz

How can i insert or introduce and analyze deformed rebar with concrete in RCC beams in ANSYS?

Can anyone tell please, how can i introduce and analyze deformed rebar in RCC beams in ANSYS? Please share any resource if you want.

11 February 2017 6,133 2 View

Theorically how is it possible to select the most economical combination of mix ratio for a concrete (e.g. 5000 Psi)?

Theorically how is it possible to select the most economical combination of mix ratio for a concrete (e.g. 5000 Psi)? Is there any procedure?

07 January 2016 3,181 4 View

How is it possible to insert a masonry (URM/RM) wall within the RCC frame in SAP 2000?

Obviously there is option of inserting wall in between frames where even the properties can be modified. But can this option give the perfect result? Since masonry wall is the combination of brick...

20 January 2014 8,777 3 View

Is there any numerical or empirical relation between compressive and bending stress of concrete?

Regarding the relation of compressive and bending stress.

30 October 2013 5,853 2 View

Is there any alternative of the conventional coarse aggregate?

Crushed stone, round stone and brick chips are generally used as coarse aggregate in concrete. What are the other options of coarse aggregate as volumetric material in concrete?

17 October 2013 8,855 2 View

Can someone suggest an alternative of sand as a fine aggregate in concrete?

Seeking fine aggregates that can be used in place of sand in concrete. Does anyone know of some?

13 October 2013 7,317 19 View

Is there any material that can be used in the place of cement (i.e. as binding material)?

It may or may not give ductility, strength, equal to the conventional concrete. What may be its cost?

12 October 2013 4,931 8 View

If 'R' is given by UTM (Fig C), what other difference in the result could occur, than the one in the real case (Fig: A)?

Please see the sketch attached. Generally Fig: A is the loading pattern (or teasing mechanism) of shear wall. 'P' is the vertical force, 'H' is the horizontal force, and 'R' is the resultant...

07 September 2013 8,736 7 View

What is the physical difference between Specific Heat and thermal conductivity?

If a material has a higher Sp. Heat than the other what is its physical meaning? If a material has a higher thermal conductivity than the other what is its physical meaning?

12 August 2013 9,704 4 View

Is there any standard for testing the strength (EX: Yield strength, Ultimate strength, density, etc) of rattan (or cane)?

Seeking advice on the strength testing

21 July 2013 5,030 0 View

What is the minimum dimension (lengthXwidth) of testing a RCC slab?

24 June 2013 4,760 4 View