Borad M Barkachary

5 Questions 14 Answers 0 Followers

Questions related from Borad M Barkachary

Why I am getting lower surface roughness with higher depth of cut during machining Al6061 with diamond?

Hello to all, In general, theory suggest that depth of cut and surface roughness are proportional to each other during any metal cutting process. On the contrary, I am getting reverse case...

12 May 2018 3,492 6 View

Is it possible to model crystal orientation using Abaqus (a FEM software)??

Hello everyone,I am trying to simulate crystal orientation related problem in FEM using Abaqus software. I have chosen Silicon with crystal orientation (100) and (110). I checked with Abaqus...

23 February 2017 1,622 3 View

Why 2D cutting simulation gives higher force than 3D simulation in abaqus?

Hello Everyone..greetings to all,I am doing cutting simulation in abaqus for brittle material (Silicon Carbide). When I did in 2D with plain strain element (CPE4R), I got comparable cutting force...

12 September 2016 3,053 15 View

How to find out Fracture strain, Shear stress ratio and Fracture energy for silicon??

Hello Everyone, I trying to model damage model for silicon, I tried the fracture strain, shear stress ratio and fracture energy values in literature. But i couldnot find any. Only mentioning...

19 July 2016 4,053 3 View

Is there any software or analytical methods to measure surface roughness (Ra)?

I know there are a no. of instruments that can be used to find out the surface profile and roughness. e.g. OM, SEM, AFM, etc. But my question is: suppose I have done deform simulation in...

18 April 2013 7,430 9 View