Asdam Tambusay

11 Questions 50 Answers 0 Followers

Questions related from Asdam Tambusay

How to define stirrup or transverse bar using ECC material in ZEUS NL?

I am confused to model the section of rectangular column section in ZEUS NL using ECC material. In the section module there is no input for the stirrup, only for longitudinal reinforcement....

03 March 2016 2,970 0 View

Does anyone know how to model reinforced concrete structure using dynamic explicit in ABAQUS?

Hi Colleagues, I want to model the reinforced concrete slab-column connection subjected to displacement controlled reversal by using Dynamic Explicit step in ABAQUS. But, It seems like I have...

11 November 2015 9,481 0 View

Is there any publication that contains the complete modeling procedure of cyclic loading analysis by using ABAQUS (whether Explicit or Implicit)?

Dear Researchers. I am currently modeling the behavior of concrete structure under cyclic loading test by using ABAQUS. I am sort of confused regarding the proper modeling technique in order to...

10 October 2015 3,464 4 View

Is there any differences between nominal shear stress for conventional concrete and for engineered cementitious material?

I am evaluating the bahavior of slab-column connections under various gravity shear ratio. The involvement of nominal shear stress on concrete material (whether using regular concrete or...

08 August 2015 1,387 9 View

How do I model concrete that has the tendency of strain hardening behavior?

As known that Concrete Damage Plasticity (CDP) has been widely used for numerical modeling in ABAQUS due to its feasibility to model quasi-brittle material i.e. concrete. However, there are types...

05 May 2015 5,303 5 View

Can anyone advise where I can find some articles about "The Calculation of Tension and Compression Recovery in Abaqus"?

I am simulating the flat slab model under cyclic loading. I am using CDPM for the material properties of the concrete. In order to define the stiffness degradation in each cycle, tension and...

04 April 2015 5,087 4 View

How can I define or calculate the tension and compression recovery on damage parameters using Abaqus?

I am having problem to determine the precise value of tension and compression recovery in CDPM Damage Parameters. Does anyone know how to obtain the exact value?

04 April 2015 935 6 View

Does anyone know how to model fiber reinforced concrete in Abaqus?

I am trying to simulate a reinforced concrete structural element in Abaqus by using PVA-ECC fiber. Due to its small dimension, what is the best way to add amount of fiber in Abaqus? I am confused...

03 March 2015 3,170 24 View

Concrete Smeared Cracking

Does anyone know how to calculate the Concrete Smeared Cracking in Abaqus using numerical approach? Or does anyone has the journal which contain the equations to calculate the Failure Ratios,...

03 March 2015 8,947 0 View

Does anyone know what is the best material plasiticity of concrete to modeling the quasi-static in Abaqus?

I am trying to modeling the slab-column connection under cyclic loading. Loads are given by using displacement controlled. I am following the procedure of geomtery model, boundary condition, and...

03 March 2015 1,818 2 View

Does anyone know the proper simulation about how to model reinforced concrete joint structure due to cyclic loading in AbaqusCAE?

Hi All, I am trying to model the flat plate structure using nonlinear analysis in AbaqusCAE 3D solid finite element are used to simulate the concrete material and 3D truss element for the...

03 March 2015 2,596 2 View