Anulekha Majumdar

4 Questions 10 Answers 0 Followers

Questions related from Anulekha Majumdar

Does it matter where we put constraint while using inertia relief in ANSYS?

I am trying to run a model using inertia relief. But if I constrain it in different places the deformation obtained is different. Also, I checked the resultant forces and moments using...

09 September 2016 7,380 0 View

What is the difference between merging nodes and providing contact between two separate bodies in ANSYS?

I have a hollow pipe which is clamped by 2 c-clamps, both are of different materials. I am doing a contact analysis in ANSYS workbench. However the solution is not converging. Can I merge the...

03 March 2016 572 5 View

What is incomplete transfer of surface loads in ANSYS?

When I merge the nodes in my model and then apply load, this warning comes "Incomplete transfer of surface loads from area 38 to elements. Please send the data leading to this operation to your...

01 January 2016 869 5 View

What is the use of the extension files generated in ansys?

.esav and .rst extension takes a lot of space in the system drive making the system slow. Files such as .esav, .osav, .x000, .rst, .rdb etc, if are important for restart of the ANSYS file, then if...

01 January 2016 1,457 4 View