Amin Noorian

6 Questions 4 Answers 0 Followers

Questions related from Amin Noorian

Problem in modeling hydraulic cylinder-piston in Abaqus using CEL technique, can any one help?

Dear All I'm modeling a cylinder-twin piston containing water but the passive piston doesn't move in the effect of fluid pressure and motion. Actually the right side piston has a velocity and the...

12 December 2019 7,056 0 View

How can I fasten 3 or more layer of solid plates in ABAQUS by means of Fasteners?

I know this is possible but I don't know how to do?!

04 April 2016 9,014 1 View

How to make a ballscrew drive by means of connectors in abaqus which its input is torque and its output is linear motion. Is it possible? How?

I want to model this joint with connectors not by real modeling a ballscew drive.

12 December 2015 9,097 4 View

How can I verify or validate my dynamic analysis in abaqus: motion of a robotic mechanism with flexible parts (video attached)?

I've imported a solid model of a parallel robot in abaqus and defined all the constraints, contacts, trajectories in joints and etc. It is moving reasonably. It's end effector has a little...

03 March 2015 7,068 8 View

Can anyone help me about time scaling factor in dynamic explicit analysis of Abaqus?

I'm doing an impact analysis in abaqus using dynamic explicit. Some times when the velocity of impact is high, the job aborts and I reduce the time scaling factor (=0.1) and it solves the problem!...

01 January 2015 3,836 11 View

How can we do fatigue analysis with cyclic step in ABAQUS which there are steel and rubber in the model as the materials?

I'm doing a fatigue analysis on a simple mount in ABAQUS which contains Steel and rubber as materials. Fatigue in the steel is important and the damage data is imported just for the steel. But...

01 January 1970 2,904 2 View