12 Questions 21 Answers 0 Followers
Questions related from Alok Jain
In my simulink model, i am getting from scope three phase voltage signal, but i need graph of individual phase graph? How can i get the individual phase graphs?
08 August 2018 9,727 3 View
I want the typical value of impedance for 0.5ohm/km line in ac distributor? can i get any reference of this whr it is used
04 April 2018 7,517 0 View
OPAL-RT Error- Some of the parameters are not double? Editin eMEGASIM- After building my simulink model in OPAL-RT, at the time of loading of the model then I am getting one error- 017-4-11...
04 April 2017 9,334 1 View
I have written code in Embedded MATLAB Simulink Block. But i am getting this error- Index expression out of bounds. Attempted to access element 2. The valid range is 1-1. What does it mean?? and...
09 September 2016 8,801 0 View
I want to make simulink model of PMU- PHASOR MEASUREMENT UNIT. I have attached paper in which PMU simulink model is given. Plz have a look and help me in making PMU simulink Diagram.
08 August 2016 6,759 1 View
As i am working on LABVIEW and i am getting some problem in it. Basically I have to estimate the phasors of any sinusoidal signal through recursive and non-recursive DFT algorithm. I have made 1...
08 August 2016 2,247 6 View
As I am working on Labview software and i have to write (Cos*theta-j*sin*theta)=e-j*theta, where theta= 2*pi/N, N=no of samples=12, in Labview. But, for this i didnt get any block in lib So,...
07 July 2016 3,713 9 View
As i am working on LABVIEW and i am getting some error problem in it. Basically I have to estimate the phasors of any sinusoidal signal through recursive and non-recursive DFT algorithm. I have...
07 July 2016 8,830 1 View
As i want to add the simulink model of PMU to my simulation but From where I can get the PMU simulink model?or from and how I construct the simulink model of PMU in MATLAB?
12 December 2015 6,253 26 View
for example if i have to mitigate Voltage sag in distribution line through smart meter?? Let voltage sag is there in the distribution line, first of all it is sensed by the Smart meter and then...
10 October 2015 5,583 4 View
in eMEGASIM- After building my simulink model in OPAL-RT, at the time of loading of the model then I am getting one error- 017-4-11 20h24m23s:You should add an OpSync block if you want to...
01 January 1970 5,661 0 View
I have already implemented AsyncIP protocol in my system. Now, I have toimplement DNP3 protocol in my system. I have use the knowledge base informationby this...
01 January 1970 5,750 2 View
