Working of MRAM device ?

Zinal Patel @Zinal_Patel2

09 September 2018 0 6K Report

Hello,

I am working on SPICE model.

I need to know about the working of MRAM device.

Any book, paper, video or your own words can be helpful. :)

Thanks a lot for your time and considerations.

Regards,

Zinal P

Badges
Science topic

More Zinal Patel's questions See All

What is the difference between BSIM and PSP device models ?

Are they really different ? Why we required to different models for single device ? What are the advantages and disadvantages of both ? Are they different related to the parameter extraction -...

05 June 2018 4,724 0 View

How to run All PVT corners in ADE L (not in ADE XL) ?

Hello everyone..Hope doing great !! I have one schematic and i need to run it on every corners (FFA,SSA,FSA,SFA,TT etc) in ADE L-Cadence TOOL-Virtuoso 6.1.6. I have an idea that it is done by...

10 November 2015 356 0 View

Brief of RF-SOI ?

What is RF-SOI?

08 September 2015 4,646 0 View

Which antenna in terms of the impedance bandwidth is known as the Super Wide band antenna?

Which antenna in terms of the impedance bandwidth is known as the Super Wide band antenna ? (in terms of ratio : 10:1(suppose).....or in % Bandwidth..)

31 December 2014 7,202 13 View

Are air moisture harvesting technologies effective in combating desertification?

Air moisture harvesting Air water collection devices

06 August 2024 5,473 2 View

Best mask design for metal deposition aiming build a Perovskite solar cell device?

What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?

31 July 2024 4,835 3 View

¿Are oxygen vacancies in semiconductors capable to change the band gap?

Dear all! Oxygen vacancies do raise negatively the Fermi level by increasing the negative charge in the semiconductor crystal structure. In the case of n-type semiconductors, I wonder if this...

30 July 2024 8,339 2 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

Charge transfer characteristics of inverted perovskite leds?

When testing devices based on ITO/ZnO/CsPbBr3/TFB/MoO3/Ag structures, I found that the current density of the device always increases sharply to 1000mA/cm2 at about 3V bias, and the device does...

16 July 2024 4,291 0 View

What do you think are the key challenges that need to be addressed in the future development and application of these three devices?

Continuous glucose monitors (CGMs) help patients and doctors make more timely management decisions by monitoring blood glucose levels in real time. An insulin pump provides continuous insulin...

07 July 2024 7,742 0 View

What is the best software for simulation of mode locked diode laser?

Hi Dear All I would like to simulate a mode locked semiconductor laser. Does anyone know what is the best software to do it?

06 July 2024 1,648 4 View

Is there any cracked version available TuFLOW software? How to get tutorials of this software?

Is there any cracked version available TuFLOW software? How to get tutorials of this software . As i want to use for modified shallow water equation in urban flood modeling and simulation

06 July 2024 2,741 0 View

Conjugate Pad absorption suddenly changed?

Hello, I am doing some testing on lateral flow devices/materials and have run into a slight issue where I do not understand what the cause may be, but I have some ideas. General Experimental...

01 July 2024 7,960 3 View

How will 5G impact the Internet of Things (IoT) and the connectivity of various smart devices and how will 5G revolutionize the Internet of Things?

28 June 2024 431 4 View