The swelling and FTIR proved chemical crosslinking of the film' however, the XRD shows that it's more crystalline than the uncrosslinked one. How is that?
I need Arduino code and a schematic for phase shifting.
17 April 2024 1,904 0 View
For implementing a prototype.
24 March 2024 4,743 2 View
I want to assess the incorporation of polymer A to a crosslinked polymer B creating a crosslinked polymer B/ polymer A blend so do I set the crosslinker concentration constant according to total...
16 January 2024 1,461 3 View
How long does a journal take to reactivate its website?
07 December 2023 7,394 7 View
The FTIR spectrum confirms the crosslinking of each polymer as well as of the blend using the same crosslinker; however, the swelling results show an increased degree of swelling of the blend that...
18 November 2023 6,693 2 View
Glycerol is known to increase the water solubility and moisture content of film but how does it affect its swelling degree?
26 October 2023 6,412 3 View
What is the Impact of Electric Vehicle Wireless Charging on the Electric Grid?
26 October 2023 5,598 3 View
The solubility test showed that the polymer has been crosslinked since it didn't dissolve; however, The FTIR spectrum doesn't show the ester peak (which is the proof of crosslinking of my polymer).
24 October 2023 6,955 2 View
Our study goal is to develop and validate questionnaire for patient satisfaction and then using this questionnaire tool to evaluate patient satisfaction then building a model to predict patient...
21 September 2023 5,552 3 View
agarose gel 1.5% TAE volt 70 at 1h
17 April 2023 302 2 View
For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...
06 August 2024 3,176 0 View
I have multiple small samples of grass pollen with anthers. I want to find a method to identify concentrations of proteins, lipids, and other various elements for these samples. any suggestions?
28 July 2024 5,331 1 View
I have images of film formed on the bottom of a 50mL beaker, and I have been trying to figure out the surface area. I could easily use features on imageJ to do that, but I want to know which area...
23 July 2024 4,461 1 View
Suggest the best and shortest route for the chemical synthesis and and green synthesis of magnetite(Fe3O4) The chemical synthesis should contain the least dangerous chemicals along with full...
21 July 2024 2,476 2 View
Chemical Engineering /Food Engineering
20 July 2024 4,152 4 View
I'm trying to create a new substance. Are there any important considerations when fabricating with CVD? For example, lattice constant If you have any such considerations, please let me know.
15 July 2024 9,359 0 View
Low magenic concenrartion indicating enhanced chemical weathering associated with warm and wet climate in detrital sediments.
14 July 2024 1,381 4 View
I am trying to measure the plasmon resonance angle of gold film and pure water using the Kretschmann configuration and a 633nm laser. Without flowing water over the gold, I can detect a clear...
10 July 2024 4,719 3 View
In order to make a polyaniline film, I used the electrodeposition method and set all the conditions, but I noticed that the polymerization process is happening, but it doesn't stick to the...
09 July 2024 2,708 2 View
Polymeric film such as latex rubber substrate or polymer
01 July 2024 8,343 4 View