Why didn't a pic of strotnium appear in the DRX results for the ZnO, Sr mixture coupling?

Mokrani Nourelhouda @Mokrani-Nourelhouda

19 May 2023 1 482 Report

I mixed 60% of the mass of strontium nitrate with zinc acetate, and the thin layers were formed by the SILAR method. When the DRX results appeared, there was no pic for strontium, there was a difference in the intensity only.

Marcella Bini

DRX stands for X-ray diffraction? Do you expect to see peaks of two different phases? One containing Zn and the other Sr? Because if a solid solution formed you only see a series of peaks, due to the mixed phase.

Badges
Science topic

More Mokrani Nourelhouda's questions See All

No title

01 January 1970 1,938 3 View

Which transition metal salt precursor is best for doping? Why?

I would like to synthesize a transition metal doped TiO2 via solgel method. Hence, I would like to know which metal salt precursor to choose among Chloride, Nitrate, and Sulphate. A clear...

27 February 2021 4,285 3 View

What reaction will occur when adding hexamine into ammonium nitrate in an acidic medium?

Hello, I am investigating properties of water in oil emulsion explosives. And adding hexamine (hexamethylenetetramine) into one of the phases that are used to make the emulsion should increase the...

21 February 2021 8,680 1 View

Are there alternatives to the Devarda alloy when estimating nitrogen?

Are there alternatives to the Devarda alloy when estimating nitrogen? devarda alloy is reducing the nitrate to ammonium

15 February 2021 8,838 3 View

ZnS oxidizes to ZnO!!why??

when I put my ZnS solution in the chemical bath, the ZnS oxidizes so there are ZnO peaks appearing because of the reaction with the oxygen in the air, despite the fact that I close the beaker...

14 February 2021 5,778 9 View

References for relative humidity created by salt solutions at different temperatures?

I understand that the ability of standard salt solutions commonly used to produce a certain relative humidity (RH) in a closed space changes somewhat with the temperature. Where do I find data...

04 February 2021 7,370 4 View

Xrd result of ZnO thin film shown better crystallinity at low temperature and the crystallinity decreases as the temperature increased. why?

I have synthesized ZnO thin films at four different substrate temperature say, 300, 350, 400 and 450C. and the samples were annealed at 450C for half an hour. the xrd result shown better...

04 February 2021 7,641 4 View

Why I do not get blue color in nitrate test of water repeatedly?

Previously, I have tried testing of nitrate in water. Sometimes I got intense blue color. However this procedure is not repeatable. It is highlighted that when I prepared diphenylamine in sulfuric...

26 January 2021 4,803 1 View

How can I prepare 300mg/L concentration of lead(II) nitrate ( Mol. Wt reffered is 331.21) incoorporated Luria-Bertani (LB) agar ?

I need to check the Heavy metal (lead) consumption assay using microbes at varying concentration in same media. ( 200mg/L to 2000mg/L).kindly help me to clear it.

19 January 2021 1,946 9 View

Which LCIA method is most suitable for assessing the impacts of nitrate leaching in groundwater (eutrophication )?

The eutrophication of groundwater by nitrate leaching is major environmental problem in Germany, especially in areas with intensive agriculture and high N-fertilizer inputs. In addition there are...

16 January 2021 5,182 7 View

What is the basis set to optimize ZnO using GaussView for DFT calculation study?

Greetings, I have a bit of problem in setup the basis set of my DFT study for ZnO.. As you can see in the image attached below, I use B3LYP 6-31G (d,p) for geometrical opt. of ZnO.. But sadly, I...

13 January 2021 7,508 4 View