i have designed axial flux pmg machine since its a low speed machine its components are nearly more compare to other type of machine. my sol of this machine also validate ,analysice without any error but the problem is when i use direct convergence method or assign more length mesh set up the result of convergence does not fully completing pass 1 to 10 after the few pass over always error message pops out your system has very low memory to solve this problem(ansys maxwell not responding) f,...k ansys and maxwell.can any one please tell me  how to fix this more memory usage of ansys maxwell .my pc specs i3 -3gen ram 4gb ddr3,1 gb amd graphics 7690hd series with intel hd 4000 series.....